Recent content by ChevyDude84

  1. C

    Problem help/suggestions

    I thinking it might almost be easier to replace the whole exhaust system... there is alot of rust on the pipes and I am sure some gasket failure some where... while I am under there I can look further at the fuel lines. What is the factory sizing on the exhaust from the headers down? I would...
  2. C

    Problem help/suggestions

    Okay guys got a little update: I checked all the lines up to the engine compartment I did not see any rub marks or broken/frayed lines... but they did look pretty rusted in some spots... I got the CEL scanned and it pulled a code of P0430 "Damaged Catalytic connector." This is different from the...
  3. C

    Problem help/suggestions

    Sorry, its a 98 5.7 4x4... (early morning pre coffee post). I will check all the lines and the charcoal canister, am I looking for obvious leaking of gas or broken lines in general? I haven't seen any leaks on the ground from gasoline... also where exactly is the fuel pressure regulator? could...
  4. C

    Problem help/suggestions

    Ok guys, it looks like the truck wants to act up on me so close to summer (grrrr) anyway I am having the following issues and need some advice on how to proceed. 1.) Oxygen sensors ( I have replaced both the sets before and after cats but they keep failing CEL comes on randomly 1-2 months...
  5. C

    Motor Ticking help

    Thanks for the response guys, I cant get to the video right now (at work) would a lifter cause a chugging sound in the exhaust? almost like the gas is expelling in intervals "putt, putt, putt"... all of this only happens on start up, once it reaches operating temp, it goes away....
  6. C

    Motor Ticking help

    Hey guys, long time no see! ok.. so it looks like the ol girl has developed a ticking noise that has progressively gotten worse. It happens at start up and then it goes away after warming up. I am trying to figure out if its the lifters or the manifold/donut gaskets. It weird because at the end...
  7. C

    Single Dynomax Bullet

    bummped
  8. C

    Single Dynomax Bullet

    What do you guys recommend for some more noise on a factory exhaust system?( please no flomaster recommendations, those dont flo lol.) specifically a muffler, and should I just to 3 inch piping from the cat back?
  9. C

    Single Dynomax Bullet

    Bump to top
  10. C

    Single Dynomax Bullet

    Is the piping after the cats 1 7/8's? prolly would be easier to get a Y pipe installed into a si/so setup?
  11. C

    Single Dynomax Bullet

    I have seen in another forum the popular size for these are 12inches... maybe a single 12' would make a difference? the next problem is finding the correct diameters
  12. C

    Single Dynomax Bullet

    what size bullet/s do you have?
  13. C

    Single Dynomax Bullet

    Hey guys, quick question. I have a 98 5.7 exhaust is all stock ( Not sure on entire system piping diameter can anybody help me with this?) but I want to install just a dynomax bullet for now and get rid of the junkie OEM muffler. Would this make the system louder with everything else being...
  14. C

    Misc K1500 Truck parts (96-98)

    Pm sent
  15. C

    Misc K1500 Truck parts (96-98)

    Pm's sent, don't be afraid to offer guys
See more

Latest posts

Staff online

Members online

... and 41 more.
Total: 1,346 (members: 91, guests: 1,255)

Forum statistics

Threads
64,768
Messages
1,400,167
Members
52,404
Latest member
Sagermeister

Share this page

Top