Recent content by BloodMoneyOBS

Starter Bolts

The TBIs generally had direct drive starters from the factory, as I understand it. The gear reduction starters started coming in for 94, and I'm pretty sure they were standard in 95.
- BloodMoneyOBS
- Post #13
- Jul 16, 2021
- Forum: Engine Performance + Maintenance
Starter Bolts

I have a 1992 Silverado, 5.7/700r4, and my starter just quit. I have a direct drive starter, stock. I'd like to change over to a gear reduction starter. I know it's a common thing to do, but I'm having a hard time confirming what part number I need for the bolts. Please sorrect me if I'm wrong...
- BloodMoneyOBS
- Thread
- Jul 6, 2021
- starter problems
- Replies: 13
- Forum: Engine Performance + Maintenance
Cruise Control Questions

Maybe this is in the wrong place, and if so, I'd appreciate being pointed in the right direction, but this seemed tangentially related. I have a 1992 C1500 RCSB Silverado with intermittent wipers and cruise control. When I got the truck, the owner told me that the cruise control had gone out...
- BloodMoneyOBS
- Thread
- May 7, 2021
- cruise control
- Replies: 1
- Forum: Transmissions
Not exactly a towing question,

But I figured you folks would be the best to ask. The Offroad guys want 4.11s in everything... I plan on putting an LSD in the back of my 1992 C1500 RCSB 350/700R4. This may not be in any way necessary right now, but I have LS powered plans for the truck. All that being said, I'm pretty set...
- BloodMoneyOBS
- Thread
- Apr 30, 2021
- Replies: 12
- Forum: Towing
Led resistors

They are 1157s, that was my bad. So, for a full LED exterior, I should just need load resistors on the front, LB - Left DB - Right Both to Ground. No need for resistors in the back? All turn signals will function as normal?
- BloodMoneyOBS
- Post #20
- Apr 18, 2021
- Forum: Paint / Body / Detailing
Led resistors

1992 C1500 Silverado RCSB Just to confirm; when doing an LED swap (1137A for the front 4 + 194As for the corners), and 3157s down the back, having already swapped in an EP29 flasher, I now need to wire in a load resistor between the following: REAR LH side turn signal - Yellow RH Side turn...
- BloodMoneyOBS
- Post #18
- Apr 17, 2021
- Forum: Paint / Body / Detailing