Recent content by 1989k2500

Transfercase question VSS

The old transmission and transfer case have been stole. I used the obd2 harness
- 1989k2500
- Post #7
- May 16, 2021
- Forum: Transmissions
Transfercase question VSS

I don’t have a 97 transfercase, it’s from the 94, it should be the same as the 97 minus the sensor
- 1989k2500
- Post #5
- May 15, 2021
- Forum: Transmissions
Transfercase question VSS

I would think a difference in teeth ( if there were any) would be a difference in accuracy not whether it works or doesn’t.
- 1989k2500
- Post #3
- May 14, 2021
- Forum: Transmissions
Transfercase question VSS

I installed my 1994 k2500 nv4500 transmission and transfercase in my 1997 k3500. The speedo doesn’t work. Should I get one for a 1997 or should it make no difference and maybe the 1994 speed sensor is bad?
- 1989k2500
- Thread
- May 11, 2021
- nv4500 swap transfer case vss
- Replies: 6
- Forum: Transmissions
Rear axle question

Yes that was a typo in the first post
- 1989k2500
- Post #19
- Nov 3, 2020
- Forum: Axles + Brakes
Rear axle question

I am swapping everything over. I have all the parts I need available. The entire front end will move over. With it, the rear axle will be swapped. Last week I’ve swapped the engine and with it every wiring harness, relay, computer and dash . I love the 454
- 1989k2500
- Post #18
- Nov 3, 2020
- Forum: Axles + Brakes
Rear axle question

A 37x12.5 16.5” tire is equivalent to about a 315/85/16.5” tire
- 1989k2500
- Post #15
- Nov 3, 2020
- Forum: Axles + Brakes
Rear axle question

Yes sir I got a sm465
- 1989k2500
- Post #13
- Nov 2, 2020
- Forum: Axles + Brakes
Rear axle question

My truck will mostly drive up to 55mph max. Maybe some time down the road I’ll get a NV4500. I have only 3 gears , but also have a granny gear.
- 1989k2500
- Post #11
- Nov 2, 2020
- Forum: Axles + Brakes
1989 Chevy 350 out- 1994 Chevy 454 in - got a question now

Thank you for searching, but as I said before, all of the trucks wiring has been replaced with wires from the 1994. But the wiring issue is fixed
- 1989k2500
- Post #17
- Nov 2, 2020
- Forum: Engine Performance + Maintenance
Rear axle question

As I probably wasn’t clear enough, I have a 3 speed manual transmission. The 454 drives very nicely, it’s got good torque,that’s for sure. I want the other axle mostly for the 8 lug hubs and 14 bolt full float. I am going to get a set of HMMWV wheels. They are 37x12.5 16.5” that’s equivalent to...
- 1989k2500
- Post #9
- Nov 2, 2020
- Forum: Axles + Brakes
Rear axle question

I have a 3 speed manual actually and am planning to get s set of HMMWV tires for her
- 1989k2500
- Post #8
- Nov 2, 2020
- Forum: Axles + Brakes
Rear axle question

now that my 89 k2500 has a TBI 454 swapped in it. I am eye balling the 8 bolt fully float rear axle with limited slip and 4.10 gearing. Now I’m not sure if it’s a good idea, being that I have a 3 speed manual transmission, so no overdrive. Right now I have a 3.73 I’m not doing much highway...
- 1989k2500
- Thread
- Oct 30, 2020
- Replies: 18
- Forum: Axles + Brakes
1994 DRAC question

I got the issue figured, one connector was laying on top of the transmission- unplugged!!! Haha Thanks for your all’s info, it helped troubleshooting the issue.
- 1989k2500
- Post #4
- Oct 30, 2020
- Forum: Engine Performance + Maintenance
1994 DRAC question

Could someone verify this ? On a 1994 Chevy k2500 DRAC, is there one or two connectors plugged in? My harness has one connector and I can’t remember taking two off and I can’t find another connector
- 1989k2500
- Thread
- Oct 29, 2020
- Replies: 3
- Forum: Engine Performance + Maintenance