Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
on my truck the map sensor and the egr solenoid are both on the side of passenger valve cover.
So last night i was gunna take the choke collar off the TB on the truck, And the Throttle cable where the cruise is on the drivers side clears just fine. But theres a bracket on the passenger side that hits the bottom of the cleaner housing, And i dont got a Hynes Manual so i dont know what it is. It has an electrical connection and box or what not, and i was wondering if i can move it down the bracket more so i can trim the top off to clean. Cant Hurt would it?
The MAP, EGR sensors, and the ESC (electronic spark control) are located on a bracket next to the TB (pass side). The MAP and EGR sensors are the smaller boxes with the vacuum tubes. The ESC is the larger flat box. Both can be re-located easily. I separated the sensors from the bracket and mounted them to the fire wall.
MAP sensor on right EGR sensor on left.
You must be registered for see images attach
You must be registered for see images attach
ESC bracket removed and ziptied to wireing harness.
Pulled the wires out of the loom without modification, just re-routed. I replaced the plastic vacuum lines with rubber so they would bend the way I needed. I think I modified the lengths.