Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Soooooo... with out having to look it up ourselves.... what is it? You got a pick of it, or a screen shot?
Sent from my SAMSUNG-SM-G891A using Tapatalk
Lol... no worries... what's are you trying to use it for? Making dual exhaust off of the y-pipe? If so why not just a 3" main exhaust(from a non emissions 1 ton) to a 3" in and 2.5" dual outlet muffler, then have some 2.5" tailpipes bent up and leave it at 2.5" at the outlet near the bumper or put some tasteful tips on it. Would seem easier then bending up 2 seperate pipes and fitting 2 seperate mufflers then tailpipe.. if that's what you where planning to try that is.. just from my experience that is..My bad
Sent from my iPhone using Tapatalk
Lol... no worries... what's are you trying to use it for? Making dual exhaust off of the y-pipe? If so why not just a 3" main exhaust(from a non emissions 1 ton) to a 3" in and 2.5" dual outlet muffler, then have some 2.5" tailpipes bent up and leave it at 2.5" at the outlet near the bumper or put some tasteful tips on it. Would seem easier then bending up 2 seperate pipes and fitting 2 seperate mufflers then tailpipe.. if that's what you where planning to try that is.. just from my experience that is..
Sent from my SAMSUNG-SM-G891A using Tapatalk
Two into oneAre you going 2 to 1 or 1 to 2? I used the Y300400 for my single 4inch and it worked great. The 2 inlets are at a 5° angle roughly. Mine was bigger than the one you are looking at but it was about 16-18" long.
You must be registered for see images attach
Two into one
Sent from my iPhone using Tapatalk