Truck will not start

[JJZ71]

ignition module....remove it...have it tested at the parts store...most likely buy a new one...

Where is it located? What's it take to remove it?

 

[JJZ71]

too bad he'll be walking out of the woods to the parts store to get one...

No walking for me! I crossed my fingers and prayed before each start up but it ran like normal.

 

[96k1500]

Not sure about the tbi but on the vortec its mounted over the pass side valve cover, if theres 9 wires on ur distributor cap one of them will run to it

 

[JJZ71]

Not sure about the tbi but on the vortec its mounted over the pass side valve cover, if theres 9 wires on ur distributor cap one of them will run to it

Oh, so were talking about the coil?

 

[96k1500]

Should be that, anything more in depth than that will usually be computer problems

 

[Swaggerwagon]

Where is it located? What's it take to remove it?

it is under the distributor cap...

looks like this..

You must be registered for see images

 

[93 K1500]

Dont forget Dialectric grease or you'll fry it quick.

 

[DRAGGIN95]

Dont forget Dialectric grease or you'll fry it quick.

Word!

 

[smburnette]

Changed mine a month or 2 ago. I believe a Phillips screwdriver was all I used. Pull the distributor cap, them unplug the module, remove the 2 screws, and replace with the new one. I know that I didn't have to unplug any plugs wires from the cap.


Sent from my iPad using Tapatalk