KyleM1990
Latest activity Postings About
-
-
KyleM1990 replied to the thread 700R acting up.1600 RPM at 55mph, 265/75/15 tires roughly 30-5/8" diameter, 3.42 gears. I haven't been able to check the pressure because I can't get... -
At what road speed? What's the gear ratio in your differential(s)? Are you running big (33 inch or more) tires?l on your truck? A...
-
KyleM1990 replied to the thread 700R acting up.My big RPM drop on a 3-4 shift seems to a drop from 2100 to about 1600 RPM. This happens most notably when letting off the accelerator...
-
What were the results of your line pressure testing? TCC application is usually accompanied by an addl 250-300 rpm drop shortly after...
-
KyleM1990 replied to the thread 700R acting up.So after a few days of everything working fine I'm having issues again. From a cold start sometimes it is perfectly normal, some times I...
-
Good deal, glad it was something simple...If it happens again, remove the governor, gov valve and polish the inner bore with a bench...
-
KyleM1990 replied to the thread 700R acting up.Well I'll have to get myself a pressure gauge. But for now I pulled the governor. I knocked out the roll pin and got the valve out, it...
-
Just take the front driveshaft off to yank the governor cover off so you can inspect the governor...No upshift, either intermittent or...
-
So as is the usual something always has to go wrong. '92 K1500. The Saturday before last I drove about 120 miles total in 95 degree...
-
KyleM1990 replied to the thread Washer nozzle replacement.Thanks everyone. I'll look into this weekend when I get some time, I'm most likely going to try to unclog it and replace the lines for...
-
If that shower head sat in muriatic acid it will give the chrome a “nickel” finish. I’ve done it.
-
If you want it done right now dip them for about 30sec. in muraitic acid. Acid won't eat plastic or glass. Rinse them well with fresh...
-
I'll add to this, you may also have some success soaking the nozzles in white vinegar to dissolve any scale that has built up in them...
-
Disconnect the hose on the backside of the nozzle. Use a rubber-tipped air nozzle to shoot air backwards through the nozzle. Anything...
-
1. Remove wiper arms - look where they mount on the wiper tower. Slide the clip down then fold the arm (may be backwards on that order...
-
-
Loading…
-
Loading…
