Supercharged111
Truly Awesome
- Joined
- Aug 20, 2015
- Messages
- 12,897
- Reaction score
- 15,863
Yoinked the bushings and the one was destroyed. For as bad as it was, I was shocked that the other side was just fine.
Luckily I'd grabbed 3 of these at the pull and pay already so good to go there. These are the same as the front cab mounts and those were destroyed on my clean 1500 back in 2018 so I expect them to be garbage on this truck. From there I used up the rest of my rust mort, must have done 6 or 8 cycles to get these **** and span.
You can see the weld I added to that mount to repair the torn/failed razor thin factory weld. I believe it failed because the bumper wasn't bolted on here, those 3 fasteners would have held this tightly against the rail.
Good enough for a plow truck I suppose. I would have painted already but my angle grinder died during my final cleanup so I guess that's my evening tomorrow before the weather tries to act like winter again.
You must be registered for see images attach
Luckily I'd grabbed 3 of these at the pull and pay already so good to go there. These are the same as the front cab mounts and those were destroyed on my clean 1500 back in 2018 so I expect them to be garbage on this truck. From there I used up the rest of my rust mort, must have done 6 or 8 cycles to get these **** and span.
You must be registered for see images attach
You can see the weld I added to that mount to repair the torn/failed razor thin factory weld. I believe it failed because the bumper wasn't bolted on here, those 3 fasteners would have held this tightly against the rail.
You must be registered for see images attach
Good enough for a plow truck I suppose. I would have painted already but my angle grinder died during my final cleanup so I guess that's my evening tomorrow before the weather tries to act like winter again.