Overheating issue...

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Joined
Jan 6, 2021
Messages
48
Reaction score
31
Location
Illinois
I’ve got a 95 Sierra I just replaced manifold gaskets on. I also replaced the thermostat just cause they’re cheap and why not... I bled the system of air a few times though I’m confident the first time worked as no air came out after that I just wanted to be sure. But, (there’s always a but) for whatever reason after initial start up say in the morning or after work it wants to overheat once getting up to temperature and shooting way past into the ”check gauges” territory. So I shut it off and pull over wait a few minutes maybe a bit less and start it up again and bam instantly shoots back to below 210. (It’s a 195 thermostat). Any suggestions. Don’t think it’s a head gasket as it’s a pretty fresh rebuild.
 

PlayingWithTBI

2022 Truck of the Year
Supporting Member
Joined
Jan 3, 2019
Messages
14,598
Reaction score
29,580
Location
Tonopah, AZ
Get a BRA-330-195 from Summit Racing. It is pressure balanced to prevent that from happening.
I have one of those in my 5.7L it does lag a little opening but doesn't go that high. It'll hit about 212* (on the gauge) then drop down to ~208* operating temp. My ECM only sees ~197* opening and then 194* operating. Not only is the gauge questionable but, it's reading between 2 cylinders in the head, not the water jacket. :33:
 

Schurkey

For a pacifist, I sure am a radical mother...
Supporting Member
Joined
Jan 14, 2018
Messages
17,611
Reaction score
27,201
Location
The Seasonally Frozen Wastelands
Get a BRA-330-195 from Summit Racing. It is pressure balanced to prevent that from happening.
Ehhhh...That's essentially what I put in my Toronado. Did exactly as the OP described--overheated from cold, popped open, good for the rest of the drive.

"Pressure balanced" doesn't mean it can't be defective.
 

Erin

I'm Awesome
Joined
Sep 30, 2017
Messages
2,383
Reaction score
6,061
Location
Southwest Louisiana
I have one of those in my 5.7L it does lag a little opening but doesn't go that high. It'll hit about 212* (on the gauge) then drop down to ~208* operating temp. My ECM only sees ~197* opening and then 194* operating. Not only is the gauge questionable but, it's reading between 2 cylinders in the head, not the water jacket. :33:
Same here. When first reaching operating temperature it will shoot up past 210, for about 2-3 seconds, then drop back to operating temperature and stay there. It's a 195 thermostat.
 

1997

I'm Awesome
Joined
Aug 2, 2013
Messages
1,359
Reaction score
3,086
Location
B.C. CDN
nope,
working good one day, next same symptom as you, pegs guage when cold in about 5 min's, thermostat opens, cools down, repeat 2 or 3 times, then runs about normal operating temp.
verified temp guage is correct and changed thermostat, stock 195 degree.
 
Joined
Jan 6, 2021
Messages
48
Reaction score
31
Location
Illinois
nope,
working good one day, next same symptom as you, pegs guage when cold in about 5 min's, thermostat opens, cools down, repeat 2 or 3 times, then runs about normal operating temp.
verified temp guage is correct and changed thermostat, stock 195 degree.
Honestly, I’m not 100% sure what was causing my issue. I ended up needing head gaskets and a bunch of other stuff and it ended up fixing it for a while. Now it will get up to temp and drop down after driving for a short time. Not sure if it’s just the way these gauges read or what.
 

L31MaxExpress

Truly Awesome
Joined
Apr 21, 2018
Messages
10,953
Reaction score
18,935
Location
DFW, TX
Honestly, I’m not 100% sure what was causing my issue. I ended up needing head gaskets and a bunch of other stuff and it ended up fixing it for a while. Now it will get up to temp and drop down after driving for a short time. Not sure if it’s just the way these gauges read or what.
My van has always shown halfway between fhe large 1/4 hash and 210 on the gauge briefly before the thermostat opens, then settles down at the 1/4 mark. 170°F thermostat and generally it runs 176-182°F at the PCM verified by IR on the thermostat housing. With a stock 195°F I could see that spike being 210°F before it opens.
 

Jeepwalker

'89 GMC RCSB 4x4
Joined
Jul 12, 2022
Messages
1,562
Reaction score
3,120
Location
WI
Your problem might have been a bad headgasket from the beginning. That can cause overheating ...and overpressurization of the cooling system. Have you been hearing a 'gurgling' noise in your heater core at all before you did the HG?

Also, its real important to get a 'good' thermostat. The quality of mainstream low-buck T-stats has gone down. That's not one part to cheapen out on.

Glad you got your rig back on the road.
 

Staff online

Forum statistics

Threads
78,031
Messages
1,643,900
Members
81,074
Latest member
Rod knock
Top