Hi guys!
I have a 95 c1500 rcsb with the manual bench seat (Absolutely sucks!)
Anyway... I have a whole suburban here and I have all the bolts and what not lined up for it. It's 6 way I believe with no lumbar support driver side is 60 portion.
My question is in terms of getting the power to it to make it work. I took a quick glance when I had daylight and did not see power cables for power seats under the floor. I would like to avoid stealing the whole harness from the burb as it's a 454 and a future project. I'm curious if I need all 6 or what not wires or if the seat would run off of a power wire and a ground just fine and how I can go about this.
Thank you in advance
I have a 95 c1500 rcsb with the manual bench seat (Absolutely sucks!)
Anyway... I have a whole suburban here and I have all the bolts and what not lined up for it. It's 6 way I believe with no lumbar support driver side is 60 portion.
My question is in terms of getting the power to it to make it work. I took a quick glance when I had daylight and did not see power cables for power seats under the floor. I would like to avoid stealing the whole harness from the burb as it's a 454 and a future project. I'm curious if I need all 6 or what not wires or if the seat would run off of a power wire and a ground just fine and how I can go about this.
Thank you in advance