eck95z71
Hightech Redneck
You should just be able to yank it off, but it will take some effort.is the factory one threaded? I tried to take mine off yesterday with no luck!
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
You should just be able to yank it off, but it will take some effort.is the factory one threaded? I tried to take mine off yesterday with no luck!
You should just be able to yank it off, but it will take some effort.
No! They are threaded on.
Sent from Rob's MeMo Tab!
New ones are not going to be. They come with some plastic bushings and you put the one that fits on and set the knob on and tighten the Allen screws and it locks down, kinda I always had to retighten mine on my manual shift.
Sent from my iPad using Tapatalk
So I finished the one I was making, turned out pretty good!
You must be registered for see images
I like that. Did you put a threaded insert in it?