4/6 drop need help

[Tamayo]

I did a 4/6 drop on my 91 standard cab, i went with the belltech flipkit, for some reason I am 1” lower on my driver side than I am on my passenger side. Anybody know why it sits this way? Any help would be appreciated!

You must be registered for see images attach

You must be registered for see images attach

 

[someotherguy]

Worn springs, bent frame, etc.

Assuming everything assembled correctly, you were already lopsided before you started, it just isn't as obvious at stock height. It's actually kind of common. Some people refer to it as "Chevy lean" but fact is, it's not something unique to Chevy's.

Richard

 

[brianmcb]

I put the belltech spacer in with my left front coil to get mine level.

95 rcsb, L33 5.3, hot cam, frost tune, 5spd, 4/6

 

[Tamayo]

Is there a way to repair a bent frame? Thanks I’ll give the spacers a try


Sent from my iPhone using Tapatalk

 

[Aarong23]

I am about a quarter inch lower on the driver said. As previously mentioned, it was probably always that and just not as apparent. You have a little more weight on the driver side with the tank and the driver. I assumed over the life of the truck, that would cause it to lean more to one side.

 

[Macfluke]

my truck is not lowered but you could use air bags and separate the controls, that's what I have on mine... when I load the bed I can adjust if its weighed more on one side...

 

[Tamayo]

Alright. Thanks guys very helpful!