What size drive belt do I need for a 1998 K1500 5.7L with A/C? I saw a few options on rock auto depending on the size of alternator. How can I tell what amp my alternator is?
Replaced the fuel pump last night. It got rid of the god awful fuel pump whine from the old one. However, I still get almost no throttle response at the beginning of my drive. Any thoughts? Maybe a new truck lol.
Sent from my ASUS_Z00AD using Tapatalk
Hey guys. I am back on this topic. I am about ready to replace my fuel pump. Dumb of me to ask how to remove the bed liner as that took me 2 seconds to do :)
Question, I want to clean on & around the fuel pump before I take it off to prevent debris from falling into the tank. what is the best...
Dealer cleaned throttle body & then tried replacing fuel filter to no avail. They said a new fuel pump may fix the issue; but not guaranteed. They said it is a fuel volume problem; not fuel pressure. They said it would be about $800 -$900 to do the fuel pump. I am thinking about doing it myself...
When I start driving either when the car is cold or warm, the truck hardly responds to the throttle. I can put it to the floor and no acceleration occurs. After several seconds, the truck starts to respond and runs fine. I took it to the Chevy dealer and they said it was due to a gummed up...
1998 K1500 5.7L
Truck vibrates (not terrible but annoying) most noticeably at 60-75mph. I also notice it when I let off of the throttle to let it coast (again, at hwy speeds). Any Ideas?
It is not the front end as I had the whole front end replaced (not because of this issue).
According to a couple shops, my rear main oil seal should be replaced. It isn't too bad of a leak, just something that should be done when possible. I am thinking I'll get it done on my next oil change.
From what I have researched, it is a one/piece seal & requires removing the tranny. Both...
Thinking about replacing hub assemblies, pads, rotors, tie rods and idler arm. Anything else I should consider while in there?
Sent from my RM-860_nam_usa_100 using Tapatalk
Thanks,
An additional question:
While coming to a stop, my ABS kicks in just before I stop. I have researched this & believe it to be the ABS speed sensors. If this is the case, I read that the sensors can either be replace or the hubs w/ new sensors can be replaced.
This Friday, I am having...
5.7 350 Vortex 99,000 miles.
Would like to do a coolant flush. What kind of coolant should go in?
What oil/filter?
Would also like to do a tune up, what parts do I need?
Sent from my RM-860_nam_usa_100 using Tapatalk
Yes. So far, I have replaced the resistor, high speed fan relay behind the glove box, blower fuse under the hood, speed switch, & I tried a new blower motor. Cursed I am.
So, I replaced the Fuse & the Speed Switch. Still no high fan. Think it could be the blower (we replaced the blower about 6 months ago with a Factory Air brand blower motor)?