Search results

  1. 2

    Smoke coming from ac control area

    So I've gotten my truck running again and tried to take it for a drive last night. Before it was parked for awhile the fan speed control switch only worked in a few speeds (usually had to turn it to full then down one step to get it to turn on, low and the 2nd position wouldn't work) so as I was...
  2. 2

    Upholstery Stapler For Door Panel Seal?

    I'd like to know as well. Does any one know if the colored piece of trim that these seals attach to is reproduced? My drivers side door panel is missing the seal and the little piece of trim that it attaches to and I haven't been able to find a replacement. I have the red interior in my 97 and...
  3. 2

    Crate engine vs rebuilding opinions?

    Thanks Mark, I'll add those to the list and look into the oil cooler. I do plan on keeping it. I talked to my local machine shop, it'd be about the same price as a GM block so I'm not sure which way to go. I'll have to run the codes on my truck and figure out what rear end and gears I have...
  4. 2

    New guy to the forum

    Thanks all!
  5. 2

    Crate engine vs rebuilding opinions?

    Thanks everyone for the replies! Didn't think about the local business aspect, will keep that in mind. At the moment I'm thinking going stock, reading into the cost of upgraded injectors, marine intakes, etc I don't really have the interest to do deal with that. If I were going to hot rod a...
  6. 2

    Crate engine vs rebuilding opinions?

    I got a 97 Sierra K1500 with about 270k miles on the original engine and would like to wake it back up. I'd like to use this truck as a sort of project/daily driver one day. I think I'd be happy with the stock power. What's the better route to go with crate vs taking to a local machine shop to...
  7. 2

    Houston/Katy TX

    New to the forum but I'm out near Katy
  8. 2

    New guy to the forum

    Hello everyone, I found this forum and have looked through it a lot already and learned a ton. I got a 97 Sierra K1500 that I've just started working on, looking forward to getting back in to wrenching.

Latest posts

Members online

... and 25 more.
Total: 1,852 (members: 75, guests: 1,777)

Forum statistics

Threads
64,345
Messages
1,391,847
Members
51,467
Latest member
jcatchin

Share this page

Top