Recent content by Kamd90Chevy

  1. Kamd90Chevy

    A/C Bypass/Delete Pulley

    Yea I'm beginning to think that's gonna be my only option to try and remedy the issue.
  2. Kamd90Chevy

    Post your lifted 2wd's!

    Has anyone looked into the newer Rough Country 6" lift?
  3. Kamd90Chevy

    A/C Bypass/Delete Pulley

    I've changed my belt tensioner twice (warrantied), an idler pulley, replaced the P/S pump pulley with a NOS GM pulley, water pump and swapped the pulley with an OE style replacement, TCI dampener when the original one finally started to separate, recently warrantied the alternator when I...
  4. Kamd90Chevy

    A/C Bypass/Delete Pulley

    Ok I'm at my wits end. About 6 months ago I removed my compressor after the pulley seized. Ever since I have battled this incessant belt squeal. Originally was only at start up to warm/low idle, progressively worked it's way to anytime it runs. I'm 99.9% sure that it's not tracking true, the...
  5. Kamd90Chevy

    CEL for Code 24

    Hey guys, my 90 RCSB 5.7/700r4 intermittently throws the CEL and I finally got it to stay on long enough for me to check it and its code 24 Vehicle Speed Sensor (VSS) Short Circuit. Now Google lead me down a couple paths of things to check and so far all I can say is my dash works just fine and...
  6. Kamd90Chevy

    Lower Radiator Hose Problems

    Well your reply made me think, open my damn tool box and use my tools lol. I hooked up my Matco pressure tester and put 16 pounds on it. The lower hose at the pump, the heater hose at the radiator side, and the upper radiator hose at the t-stat housing all leaked. Had to remedy all of them. Then...
  7. Kamd90Chevy

    Post your lifted 2wd's!

    Ok so i'm ordering the RC 4" spindle lift and the notes state that Light duty brake trucks need to change brakes to make it function. I know i'm looking at Pads, Rotors, Bearings and Seals. Am I also looking at calipers and brackets? I already have Russell stainless braided lines and 3 months...
  8. Kamd90Chevy

    Lower Radiator Hose Problems

    OK guys, I've been wrenching since i was 9 with my Dad. I'm no master tech but this is really starting to gripe my bum. I've had a problem with my lower radiator hose leaking past the clamp at the water pump side for months. So i changed the lower hose and clamps, thinking the rubber was aging...
  9. Kamd90Chevy

    94 C1500 Suburban HVAC Control Issue

    Ok so i found out if u cross the 2nd pin from the left on the connector and use a test light to close the connection on my 90, it kicks the blower. So after everything else i tried it on the 94 Burb and it would only kick the relay (which i ended up following the wires to a bracket with 4 relays...
  10. Kamd90Chevy

    94 C1500 Suburban HVAC Control Issue

    Well i had the 2 junkyard units with me at the house and i tore my 90 apart and hooked them up knowing mine worked, and neither used part functioned. So that ruled that out. And unfortunately that is my luck these days. Trying to avoid the $100 on the new one from LMC Truck. But i haven't made...
  11. Kamd90Chevy

    94 C1500 Suburban HVAC Control Issue

    So out of curiosity I went to the junkyard and bought 2 other HVAC controls for about 15 bucks. i tried installing both of them and got the same results. So I guess i'll be ordering a new one. I want to take mine off my truck that i know works and plug it into his but i'm super sketch about if...
  12. Kamd90Chevy

    94 C1500 Suburban HVAC Control Issue

    Hey guys and gals, i bought my dad a 94 Burb a couple months ago and have been working on it off and on as my work schedule allowed. I got all the mechanical taken care of, some tires and brakes, new light kit etc etc. However, the one thing ive not been able to get to work is the damn HVAC...
  13. Kamd90Chevy

    1990 C1500 ABS (RWAL) removal.

    Finally got around to doing this to my 90 RCSB 2wd. Even after i had swapped on the SSBC brake kit and changed the calipers, i still was getting the notorious bounce. After this delete, my pedal is always solid and no brake fade or bounce. I also added a set of Russell stainless line kit for the...
  14. Kamd90Chevy

    Project; Burnt Up

    Just out of curiosity, did you ever happen to look at what size tire they had on the 15's on the rear? I'm oddly curious how they stuffed that in stock tubs.
Top