Travis_Culler
Newbie
So I just had this 700R4 rebuilt for my '88 SBC 350 2500. I went to slide the Yoke in for the drive shaft, and I was bumping into something at 2" depth on my Yoke. So I thought I either have a burr on a shaft spline, or maybe im catching the edge of the bushing. Anyway, I pull the Tail housing off, and this sleeve has been inserted on the front splines. The sleeve is flared toward the rear, and the end of my yoke seats perfectly into the flare. But my yoke is nowhere near deep enough. Do I need to remove this sleeve and replace it with a shorter one or something?
Im not a seasoned mechanic and Im definitely not experienced in anything transmission related. Can somebody help me out here? Ive attached pictures of the Yoke seated to the sleeve with the tail housing on, and a picture of the output shaft.
Im not a seasoned mechanic and Im definitely not experienced in anything transmission related. Can somebody help me out here? Ive attached pictures of the Yoke seated to the sleeve with the tail housing on, and a picture of the output shaft.
You must be registered for see images attach
You must be registered for see images attach