so I replaced a 700r4 with a 4l60e and got myself a complete harness with 0411 ecu from a 2002 blazer with a 4.3 and 4l60e as well. I have read the writeup from sloppy mechanic about this as well and so far I managed to get the tps to work just fine.
RPM is more complicated because the 88 tbi does not have a ckp sensor so right now the ecu does not have rpm signal, but all the wiring from the ecu to trans is all stock untouched harness so I will consider good for now.
apprently rpm is only needed for wot shift ? but looking at my scanner, the commanded gear is always at 3, if I down shift to 1 on the column shifter it command the 2nd gear only. I tried to follow the instruction as best as could for setting it up correctly in tunerpro first but I only have basic understanding of it.
looking for insight about what would keep it from going into 1st gear and what setting in tunerpro need to be modified to work, thx
RPM is more complicated because the 88 tbi does not have a ckp sensor so right now the ecu does not have rpm signal, but all the wiring from the ecu to trans is all stock untouched harness so I will consider good for now.
apprently rpm is only needed for wot shift ? but looking at my scanner, the commanded gear is always at 3, if I down shift to 1 on the column shifter it command the 2nd gear only. I tried to follow the instruction as best as could for setting it up correctly in tunerpro first but I only have basic understanding of it.
looking for insight about what would keep it from going into 1st gear and what setting in tunerpro need to be modified to work, thx