jps4jeep
I'm Awesome
the the rear hanger is supposed to hang lower, go look at any 73-87 front
What he said, reduces axle wrap.
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
the the rear hanger is supposed to hang lower, go look at any 73-87 front
No, 15" rims will fit 1/2 D44.
On the 3/4 ton, should fit, but depending on your backspacing, you might need to clearence the caliper some.
my 52's are 2.5 wide, i had to add a spacer in the front hanger as it was meant for 3" wide and the hanger is from a 84 k5 so it would have been a 10bhere's a new one,
when you use chevy 52's up front and it's a 10 bolt with the one wider u bolt on the PS, what spring/u bolt plate do/can you use?
almost all the aftermarket ones I see say 3 inch axle tube and 2.5 wide springs, but rear springs are 3 inch wide right?
my 52's are 2.5 wide, i had to add a spacer in the front hanger as it was meant for 3" wide and the hanger is from a 84 k5 so it would have been a 10b
what did you guys use for spacers?
also since the gm 10 bolt and the 44 knuckles have the tapers opposite ways, could I take the DS gm 10b and drill it out solid no taper, then use one of the taper inserts like wfo sells and make that work to line up that center tie rod to be the same on both sides?