my bagged 1967 suburban

[project 67 sub]

Sneak peak of some of the things I plan on using some bullet casings for.

You must be registered for see images attach

Trans cooler, and modified bracket cleaned and painted... looks basically new again. Now I just need to find some new line fittings for it

You must be registered for see images attach

 

[project 67 sub]

Gonna start doing clean up, a few mods, and changing/replacing a few things soon for the swap

You must be registered for see images attach

98-02 f-body oil pan swap, and a -10AN bulkhead for the turbo oil return done

You must be registered for see images attach

 

[project 67 sub]

Heck yes! New rods, and main bearings came yesterday. Replacing them just for piece of mind (since it supposedly came out of a rolled over tahoe).

You must be registered for see images attach

More truck parts (50bmg).

You must be registered for see images attach

 

[slick96]

Your burb is truly a work of art. Very, very, impressive. Looking forward to future updates

 

[project 67 sub]

thanks.



a few small updates...
it's still not 100% perfect, but much cleaner now. Degreased and pressure washed it. Almost time to start changing some parts

You must be registered for see images attach

New water pump to replace the old original one i accidentally broke. lol

You must be registered for see images attach

 

[project 67 sub]

and its officially out... and for good. gotta do some clean up, repainting, and maybe relocating a few things before the 5.3 eventually goes back in

You must be registered for see images attach

out with the old. need to clean up, regasket/seal, and paint the transmission for when it gets reinstalled

You must be registered for see images attach

 

[1sickcrewcab]

Sick build!!! Nice job

 

[project 67 sub]

Sick build!!! Nice job

thanks. yours is pretty bad ass as well.


more updates...

Cleaned up and partially painted. Relocating the front air ride valves off of the firewall, since the passengers side ones are gonna be in the way of the exhaust dump/cutout once its turbo'd

You must be registered for see images attach

Coating the SloshTubz with some rattle can spray on bed liner as well while I have it apart

You must be registered for see images attach

Future exhaust cutout/dump location. Might cut/notch a section of the fender bracing, and firewall for some extra clearance, and so I can run it out the fender at a 45° angle

You must be registered for see images attach

 

[camoburban]

What did you use to paint the frame. I almost want to pull my granny just to clean mine up. Lol.
But I'm sure that would lead to a lot more money aNd parts I'm not ready for!

 

[project 67 sub]

What did you use to paint the frame. I almost want to pull my granny just to clean mine up. Lol.
But I'm sure that would lead to a lot more money and parts I'm not ready for!

lol. i know how it is. and its just rattle can semi-gloss rustoleum spray paint


more updates. lol.

got the other fender off, and finished painting the firewall and stuff

You must be registered for see images attach

got the other SloshTub coated in bed liner as well

You must be registered for see images attach

And back on. Now I gotta make a make a block off plate for the clutch linkage hole, remount the air ride valve somewhere else, remove the old fuel line, and do a few other things. Then it will be ready to drop the 5.3 in once that's ready

You must be registered for see images attach

Clutch pedal linkage hole cover, and accelerator pedal rod hole cover made, painted, and installed

You must be registered for see images attach