Mr_Pud
OBS Enthusiast
Alright got a couple things done but mostly been doing some research on my rear end. Can some one help me with tolerances? On this pic
Sent from my SM-G900V using Tapatalk
You must be registered for see images attach
I was measuring backlash and it was .008 in the same pic I held the axle in place and I could move the ring gear .04 and then in this pic
You must be registered for see images
I held the ring gear and the gear inside would move .04 I think it's the spider gears??? They look the worst worn Also I measured in the pic how much carrier would move side to side .003
You must be registered for see images
.. so I'm most likely going to order spider gears new bearing kit for Pinon and carrier and also wheel hub bearings.. 460 bucks it most likely has never had any work 200k miles it's probably ready for a rebuild and since the one bearing is out might as well replace em all.. let me know what you think thanks.Sent from my SM-G900V using Tapatalk