Turn signal, hazard lights and brake lights stopped working!

[Thor-Egil Lerbrekk]

Now it's working! All but turn-signals. Have changed out the blinker-relay (standard electronic relay) and turn-fuse without success.

Hazards, brake lights works perfectly and the brake-lamp on the dash is gone. Gone through almost all wiring, grounds and bulb-holders. The stop fuse was blown. Can not imagine I could overlook that. What is the difference of the brake-fuse and stop-fuse? Guess I should get me a manual.

And by the way - how can I cancel the "Service engine soon" lamp?

 

[Schurkey]

And by the way - how can I cancel the "Service engine soon" lamp?

Disconnect battery for thirty seconds.

When you reconnect and run the engine, if the SES light comes on, you'll want a scan tool to look at the codes and data stream to determine what's wrong.

 

[Thor-Egil Lerbrekk]

Battery has occasionally been disconnected for hours. Tomorrow I will try pull codes with a paperclip from the OBD port under the dash.