Scrufdog
Pork chop sandwiches
- Joined
- Feb 4, 2014
- Messages
- 326
- Reaction score
- 5
Soonish I will be installing dual exhaust on my 1995 Suburban. I was thinking for easy of installation I might be able to get 2 mandrel bent stock pipes and take one of them and reverse right after the axle hump, bascially cut the tail end of end and rotate that piece and weld it back together so that the exhaust exits of the driver side. This will all be bolting onto long tube headers and mufflers, with an h-pipe. Does this sound feasible, anyone tried it yet? I'm going to check tomorrow for anything that might be in the way on the drivers side, I might just shorten the pipe all together if needed and bring it out closer to the wheel, or even before the wheel.
Thoughts?
Thoughts?