David89gmc
OBS Enthusiast
- Joined
- Nov 15, 2018
- Messages
- 67
- Reaction score
- 34
Appreciate any comments you may have.
I just bought an '03 K2500HD that turns out to have a bent frame. The front end is bent upwards about one inch, so the winch bumper angles up slightly.
I can't see any obvious bend or damage on the frame, but the front of the frame took a really good blow, evidenced by the bent skid plate under the front axle. Measurements show the frame isn't twisted.
Question is: Can this be left as is and can the wheel alignment be set with this amount of damage?
Thank you.
I just bought an '03 K2500HD that turns out to have a bent frame. The front end is bent upwards about one inch, so the winch bumper angles up slightly.
I can't see any obvious bend or damage on the frame, but the front of the frame took a really good blow, evidenced by the bent skid plate under the front axle. Measurements show the frame isn't twisted.
Question is: Can this be left as is and can the wheel alignment be set with this amount of damage?
Thank you.