single cab

  1. H

    Door not closing tight

    I've got a 1997 Chevy C1500 2WD Single Cab Work truck and the drivers side door has some difficulty closing easily. When you throw the door closed it doesn't appear to latch tight and can be wiggled open and closed a bit. If I close the door holding it and ensure to push it tight during closing...
  2. Lawrence Bouchelle

    1990 c1500 jb3 brake upgrade help

    i have a 1990 single cab short bed with a lq9 swap i just got, it has stock brakes that are really bad like underivable. Ive looked all over this site and i think i know the best upgrade keeping 5 lug. some 1996 brake rotors, pads and hubs and some junkyard spindles. Then for the master im...
  3. 106x

    Single cab sub setups

    I have a 1996 c1500 I've been redoing the audio on and im at a stump at what I should do for subs, are you guys running two shallow mount 10's or smaller? what boxes are you guys running? photos of behind the seat setups, and do and of you guys have any under the seat setups? I wanna bump but I...
    • 106x
    • Thread
    • audio recommendations single cab
    • Replies: 14
    • Forum: Audio
  4. M

    Driveshaft question

    I have an 88 1500 single cab. It originally came with a 305 and a th400/th375. The transmission had went out and I threw in a 700r4 not thinking much of it. I got to the driveshaft and now I’m short. It’s one to have a long driveshaft, but with short im looking at getting a longer shaft. My...
  5. NoShawnMarino

    New member from Wisconsin

    Hi guys, just stumbled across the forum here, and thought it would be the best place to be seeing as I’m the owner of a 1993 Cheyenne 2500. (New rims are in order, would like to change up the look a little bit.) I’m from SE Wisconsin, big time Packer fan, fan of all types of racing. And just...
  6. T

    Not starting after doing a De-Carb on engine

    I really need help! Yesterday I did an engine de-carb on my 1988 k2500 at work. Nothin unusual happened while i did the de-carb and I even drove it home after without any issues. However after letting it sit all night i went to start it this afternoon and it doesn't crank I only here the starter...
  7. T

    ECM trouble dtc 51 PROM error

    I recently purchased a 1988 Cheyenne K2500 4X4 and a couple of days ago the truck stalled while idling at a red light and the power seems low when accelerating. I got home and noticed the SES light came on so I checked for any codes and I got code 51 which says there an error with PROM. I...
  8. 4

    Performance Issue on 1993 C1500 1/2 Pickup Single Cab

    This is my current truck, totaled the bike so back to truck fixing! Been having some issues where it sounds like the engine hesitates on idle, the RMP needle will move up and down and will begin rumbling a bit on idle. It turns on well, but once Im at a stop it pulls itself forward I thought i...
  9. V

    Drive train / Pinion yoke Question please help

    Good evening, I recently had a minor accident where my drive shaft came off while going 70 on the freeway. After getting my 1500 back home I took a closer look and my drive shaft came from the pinion yoke due to one of the U-joint needle bearings falling off. I have provided pictures of this. So...
    • Vddiaz94
    • Thread
    • 1992 asap c1500 drive shaft help please rear dif short bed single cab yoke
    • Replies: 2
    • Forum: Transmissions
  10. T

    6.5 won’t start

    Alrighty so I have a 1994 k3500 with a 6.5 td that cranks but will not start. I took it into a shop to get diagnosed and they came up with the injection pump being bad and quoted me 3.5k for a repair. Do you guys think that it is the problem, and if so would I be able to just buy one and fix it...
  11. joshloaf

    My 1989 Silverado Stepside Restoration

    Hey all, nice to meet you ! My name is Josh and I’ve just recently decided to restore a 1989 Stepside that my father’s childhood best friend used to drive daily. He parked it when the tranny blew at 120K and let people strip it of parts over the past 7 years, so it got down to bare bone remnants...
    • joshloaf
    • Thread
    • 1989 silverado 350 305 tbi 5.7 5.0 obs oil pan engine motor automatic k1500 parts rebuild restoration single cab stepside
    • Replies: 13
    • Forum: Introduction
  12. I

    Driveshaft length on a single cab long bed 4wd 700r4?

    Hey all! I'm new here, but have always loved my OBS's. (Surprised this name wasn't taken) I just bought a beautiful 88 GMC, however it needs both driveshafts, I've already got the front, but in having a time finding a rear. Does anyone know how long the driveshaft for this truck would be? I...
    • ILoveTBI
    • Thread
    • 4wd drive shaft gmc long bed single cab tbi
    • Replies: 5
    • Forum: Transmissions
  13. DeputyPelican

    "Red Rock" 97 C1500 Build

    1997 GMC Sierra SL 2WD with a 262 4.3L engine, and 4L60E transmission. Little history of the truck to preface the thread.. The truck was sold in 1996 to my Uncle by my Dad was a vehicle salesman at the local GMC dealership. My Uncle used the truck mainly for various errands, all on...
  14. Treyes

    4.3 tbi v6 cam and lifter questions (1992)

    Got myself a 1992 4.3 tbi single cab as my first truck and it does its job, but as a highschooler i want it to be as fast and loud as it can be so im looking to buy a cam and anything else i can afford but i need yalls help figuring put what is best for the money so any recommendations im all...

Latest posts

Staff online

Members online

... and 2 more.
Total: 2,855 (members: 52, guests: 2,803)

Forum statistics

Threads
77,810
Messages
1,640,251
Members
80,492
Latest member
subven69
Top