Recent content by Vodka0tter

Holley Terminator X EFI

Truck is a '97, 383 vortec base. I wired up an Edelbrock Pro-Flow MPFI which is working fine, 0411 PCM. I have hacked into the wiring harness so many times now, I cant believe it still runs? No A/C, EGR, Cruise, Antilock, airbags, T56 swapped... Pretty basic at this point and everything removed...
- Vodka0tter
- Thread
- Jun 13, 2022
- Replies: 1
- Forum: Engine Performance + Maintenance
ABS delete

The pedal in my '97 RCSB still is pretty poor IMO. Pretty significant travel before the brakes engage, soft after engagement and improves with a pump or two. I put little shop rear disc, disc proportioning valve, NBS master cyl, new booster, all new lines & SS hoses, Little shop front set up...
- Vodka0tter
- Post #34
- May 18, 2022
- Forum: Axles + Brakes
Neutral Safety Switch bypass

Yeah, think its purple (starter relay) from the fuse block under the hood and Yellow (Ignition wire) wire from the steering column. I know the purple goes to the solenoid.
- Vodka0tter
- Post #5
- May 17, 2022
- Forum: Transmissions
Neutral Safety Switch bypass

I did a trans swap from auto to manual in my '97 RCSB. Started this almost 2 yrs ago, things got in the way but wrapping it up now. When I removed the auto, I chased all the wires back to the PCM and unpinned them. So I know I have a NSS problem because I removed the wiring. I'll tie this into...
- Vodka0tter
- Thread
- May 16, 2022
- Replies: 8
- Forum: Transmissions
2002 sunvisors in 98 Burb

Glad I found this thread. My 99 tahoe is getting an up grade soon! I have the MGT800 visors, was just stuck on the install...
- Vodka0tter
- Post #20
- Mar 4, 2022
- Forum: OEM and Custom Interiors
02 sensor/ENG1 fuse circuit. Elect Gurus - help please!

Perfect! It’s 12.2. thanks for the help guys, appreciate it!!
- Vodka0tter
- Post #6
- Aug 16, 2020
- Forum: Audio + Electronics
02 sensor/ENG1 fuse circuit. Elect Gurus - help please!

So pink hot from the fuse box should show ground if it’s the heater circuit on an o2 sensor? Also grounds out all other circuits on that buss bar. Seems odd but I know little about circuitry
- Vodka0tter
- Post #4
- Aug 16, 2020
- Forum: Audio + Electronics
02 sensor/ENG1 fuse circuit. Elect Gurus - help please!

It is part of the heater circuit...
- Vodka0tter
- Post #3
- Aug 16, 2020
- Forum: Audio + Electronics
02 sensor/ENG1 fuse circuit. Elect Gurus - help please!

I am not sure if I have a problem or not. I went in for a tune this spring and the tuner guy says your odbii is dead. I locate what I think are 2 shorts in my wiring. 1 in the cab - I have located that one. While looking at the power dist. box (fuse box under the hood) I note that many of my...
- Vodka0tter
- Thread
- Aug 16, 2020
- Replies: 5
- Forum: Audio + Electronics
Under hood Power distribution block power

okay - thanks. I am chasing a short down that started with the power to the ODBii showing a short in the orange power supply to it (ODB is not powering a code reader or providing power to for tune). I found ground faults in two places that show hot to hot to ground. I jump the batty leg from...
- Vodka0tter
- Post #3
- Aug 11, 2020
- Forum: Audio + Electronics
Under hood Power distribution block power

Stupid question... Regarding the power distribution block under the hood, what source is the 50 A fuse labeled Betty? Is that a direct feed from the batty, the main power supply?
- Vodka0tter
- Thread
- Aug 11, 2020
- Replies: 2
- Forum: Audio + Electronics
Aftermarket gauges?

Well, obviously I have no idea how to show a picture from my media...
- Vodka0tter
- Post #16
- Jan 13, 2020
- Forum: OEM and Custom Interiors
Aftermarket gauges?

0tters dash by Vodka0tter posted Jul 11, 2019 at 6:18 PM Aerometer mounted on a cut sheet of plastic 0tters dash by Vodka0tter posted Jul 11, 2019 at 6:18 PM
- Vodka0tter
- Post #11
- Jan 12, 2020
- Forum: OEM and Custom Interiors
Gotta love those 4L60E's(insert sarcasm)

I push ~ 500 hp out of my 383 into a 60E (and a 10 bolt for that matter). They both see action with 10" slicks putting my yank 3200 stall to work. While mine is not DD I gotta say an ounce of prevention goes a long way in quality parts and maint (fluids, filters, cooler, frequent inspections)...
- Vodka0tter
- Post #13
- Nov 4, 2019
- Forum: Transmissions
97 1500 steering box replacement

https://www.amazon.com/Universal-Steering-Joint-Stainless-Steel/dp/B00VA0YGT0 Just make sure you match the spline count and dia.
- Vodka0tter
- Post #18
- Oct 6, 2019
- Forum: Engine Performance + Maintenance