Recent content by Truckracer

  1. Truckracer

    7.4L Vortec fuel pressure regulator relocation 1997 3500

    And for the record -Short term fuel trims are running 0 to 1.7. Long term trims are 3.5 to 4.7…
  2. Truckracer

    7.4L Vortec fuel pressure regulator relocation 1997 3500

    Just look up a 1999 corvette Fuel filter / regulator. And yes I crimped off the return. ACDelco Gold GF822 Fuel Filter - but you need adapters.
  3. Truckracer

    7.4L Vortec fuel pressure regulator relocation 1997 3500

    After owning this truck for 7 years and replacing 4 FPR's I really got tired of working on it. The last AC Delco only lasted a few weeks. So I came up with a solution I've never seen anyone else try. Corvette Filter/regulator mounted in the factory fuel filter location. 58psig continuous. Yes I...
  4. Truckracer

    1997 3500 4l80e problems

    Truck has always been perfect until a week ago. Took off for town and the trans was in second gear and then started shifting between second and first, rapidly. I slowed down some and then it just went to second and stayed, limp mode I assume. no check engine light, no codes with my scanner...
  5. Truckracer

    Headers for 454

    The frame in these trucks just won't allow a square body header to get close to fitting. I found these today Patriot Exhaust H8058 Headers, 92-95 Chevy Truck, Raw, 1-3/4 Inch - $294 from Speedway motors.
  6. Truckracer

    Headers for 454

    Fortunately for us Chevy made the 454ss trucks, so the aftermarket does have some headers that will fit your truck. JBA Headers 6822S Ho@ker Headers 2461HKR Hedman Hedders 69571 JBA Headers 1822S-2 Ho@ker Headers 2847HKR Hope this helps.
  7. Truckracer

    BIG BLOCK HEADERS FOR '94 4x4??

    Not a lot of choices for big block headers, and only one I know of 2" primary's, Hookers @ $705.00. I'm building a 96 with 496 that should make 675hp so the 2" is a must.
  8. Truckracer

    Headers for 1999 L29 7.4l 4x4

    I'm interested as well. Building a 96 2wd that was originally a v6 truck. I've got a 496 to go in the truck.
  9. Truckracer

    Best Flow manifolds

    The worst short tube or long tubes will kill cast iron manifolds... But, if you must there is only one name, Brezenzki, https://www.castheads.com/manifolds-carb/exhaust-manifolds/log-style-chevy-ii-exhaust-manifolds/
  10. Truckracer

    Need more get up and go!!

    Well, no. See my other thread. I did mine for under $75.00. You can adjust on the fly while driving if need be, Change tire sizes? reset in under 5 minutes. Change gears, again, 5 minutes.. Easier than a drac truck, no need to cont a tuner to have it reset. Even if I had a tune I would use the...
  11. Truckracer

    Speedometer correction - 98 Vortec truck

    With a tire change the speedometer in my truck was 6 to 7 mph off at higher highway speeds. I researched until I was tired of the many ways to bring the accuracy back. I needed a low cost method. I wasn't willing to pay for a tune I don't need or a tuner I have no other use for. I know many...
  12. Truckracer

    98 Vortec - timing retard issue

    Well, I don't think so. It does happen below 2400, just infrequently.
  13. Truckracer

    98 Vortec - timing retard issue

    Oh yea, its repeatable. With the cooler weather now it does it as the compressor runs for the defrost. This has nothing to do with the brand new distributor. I replace the old one in an effort to find the cause. I'ts definelty the knock sensor picking something up when the compressor kicks in...
  14. Truckracer

    Speedo Question

    You need this. http://www.dakotadigital.com/index.cfm/page/ptype=product/product_id=916/category_id=311/mode=prod/prd916.htm Dakota digital SEN-01-128 128k GM-style High Frequency Pulse Generator
Top