Recent content by KansGeo

95 Suburban rear heater hose questions

For reference for anyone, the hose will slip over the “bead”. I will probably use two spring clamps, one on each side of the bead. I did get a new hose/tube assembly that routes from underneath the mid-vehicle to the “heater T’s “ in the engine compartment from EBay for about $80...
- KansGeo
- Post #44
- Oct 29, 2023
- Forum: Engine Performance + Maintenance
95 Suburban rear heater hose questions

Nitro I haven’t taken one apart yet … want to have a good plan before I order parts. Notice in the mid section photo, one end of each hose connects to where there was a quick connect fitting. The other hose end connects to the tube where the old hose had a factory crimp connection. I...
- KansGeo
- Post #42
- Oct 25, 2023
- Forum: Engine Performance + Maintenance
95 Suburban rear heater hose questions

Nitro Junkie….As best I can tell by measuring with an electronic caliper gauge, all the hose to metal lines connections for the auxiliary heater are .75 (or very close) (difficult spots to measure accurately) including the rear heater inlet/outlet on my suburban. I think the only 9/16 or...
- KansGeo
- Post #40
- Oct 25, 2023
- Forum: Engine Performance + Maintenance
95 Suburban rear heater hose questions

Help please…On the suburban rear heater, mid frame photo above, would the 3/4 or 5/8 hose push over and past the bead on the metal tubing lines? Would the hose stretch without damage. Put clamps on after the bead of course. I need to replace the hose on my 1994 Suburban. LOL…that not a...
- KansGeo
- Post #38
- Oct 25, 2023
- Forum: Engine Performance + Maintenance
95 Suburban rear heater hose questions
- KansGeo
- Post #37
- Oct 25, 2023
- Forum: Engine Performance + Maintenance