Recent content by justin12234

  1. J

    What are you running?

    right now im using fully stock but going to upgrade to jvc kd-s38 and a Jensen lxa 600 watt my dad had in his truck before he sold it, im just hoping i dont need crossovers for the stock front speakers
  2. J

    Magnaflow true duals!

    imo it sounds pretty damn good, not too loud or quiet and a deep sound, sounds hell of a lot better than my single lol
  3. J

    removing egr?

    thanks guys, was gonna do this on sunday but it rained enough to where everything was wet and i couldnt work outside, now its gonna be pouring rain for the next few days from the tropical storm and ill have to wait until next weekend along with a oil change, transmission fuild check/change, and...
  4. J

    removing egr?

    we didnt have time to check it because it almost time for my dad to go to work, ill check it either today or have to wait until next weekend
  5. J

    New guy with a Z71...

    the main thing i like about the gmt400 is being able to work on it without having to take it to a shop, i love working on it when i can
  6. J

    removing egr?

    i think i know what you mean, theres a hose coming from the solenoid to the tbi and on the other side going to the egr and a vent, and i plug the one going to the tbi? like J on this picture? (its not the same diagram as mine but its similar)
  7. J

    New guy with a Z71...

    i love it when people find bargains like this, my dad got mine for around $630 and all it needed was the egr to be blocked off and the 4wd actuator that we got in a junkyard for $10 and is good to go
  8. J

    removing egr?

    i was planning on getting this one when we go to oreillys for some oil changes in mine and my dads silverado next weekend. do i also have to plug off any vacuum hoses?
  9. J

    removing egr?

    one of my dads friends looked at it and he also said it looked liked it was stuck open, and i think im going to buy the egr block off plate next weekend. and its not a vortec, 5.7 tbi and im not sure if this is correct info or not but i looked on a few sites and said alabama doesnt require...
  10. J

    4l60e 1-2 accumulator piston?

    when i drive the truck normally the 1-2 shift is a lot higher rpms than 2-3 and it shifts at lower rpms, and when i go all the way to WOT it almost red lines before shifting into 1-2, is it suppose to shift at these points? ive never really looked at the rpms for 2-3 and i will next time when...
  11. J

    removing egr?

    can i remove the egr without any bad effects on the motor? it hardly would run or anything with it hooked and and we unhooked it and it runs like new and holds a steady idle and doesnt cut out through the rpm range when driving. and could i have screwed something up big time by accident when i...
  12. J

    95 k1500 showin abs codes

    from FSC
  13. J

    95 k1500 showin abs codes

    it was the abs light, i check the codes and all the service engine soon light gave was code 12 and the abs gave code 21 and 65
  14. J

    95 k1500 showin abs codes

    abs light came on a few days ago and wont go off, i checked it for codes and its showing code 21 and 65, any ideas on what would cause this and if it is the source of my acceleration problem at low rpms?
  15. J

    removing dents

    any ideas on how i can remove these dents? there's also a small dent under the door handle where someone tried to break into it before we owned it, and ideas on repairing it? i think i can probably get under the bed with a rubber mallet and straighten some of the bed up, not sure...
See more

Latest posts

Members online

Total: 1,324 (members: 33, guests: 1,291)

Forum statistics

Threads
64,561
Messages
1,396,654
Members
52,017
Latest member
R3MtnRunner

Share this page

Top