Recent content by Cpufreak101

  1. C

    Arteb Headlights / Taillights End-of-Life (?)

    nice to hear for the tail lights as well!
  2. C

    96' K1500 5.7 no crank/no start after swap

    alrighty. doing some extra looking, thanks to this post: https://www.gmt400.com/threads/88-98-service-manuals.43575/post-1246113 I was able to grab a wiring diagram of the starting system and got it colored in to make it easier to follow. from what I can see, assuming there is power to the...
  3. C

    96' K1500 5.7 no crank/no start after swap

    To rule out the "easy" issues, you getting 12V on the big wire to the starter solenoid at all times? and when you crank are you getting voltage to the smaller wire? As they said above could just be a case of the starter solenoid wire got damaged when the engine dropped.
  4. C

    Wiring changes to suit ARTEB taillights

    Additional information to top post: I realized I forgot to show the wire that had to be cut on the turn signal switch. This is it. Try to cut it on that side of the connector as this preserves the vehicle's factory wiring
  5. C

    Wiring changes to suit ARTEB taillights

    Well here is the video I have promised. A fair warning, I did this all in just one take and I'm not the smoothest of speakers, so I hope that doesn't detract from the information in the video. A couple corrections that need to be made already: as per the post above this it does seem there's...
  6. C

    Acquiring Arteb Brazil GMT400 taillights

    I can confirm for a suburban that, due to not having any possible way to have a bed topper, they likely don't have the extra brake light wire and would need to be ran from the front, and the wiring diagrams do have slight differences in trucks past '95 that I haven't checked yet (I know the...
  7. C

    Acquiring Arteb Brazil GMT400 taillights

    An issue with this solution is that it actually won't carry through a hazard light signal as it has no way of differentiating the brake from the turn signal in that scenario. It may work if you're a bit afraid of wiring and you don't live in a country requiring amber turn signals (as hazard...
  8. C

    Finally got myself a GMT400, '94 C1500

    Well been a while since I've posted to this thread. The truck is no longer a daily driver so not a lot's getting done to it at the moment. However, I went to a local place for its first (and now yearly) undercoating since I owned it. Steel City Oil undercoating actually gave me a call stating...
  9. C

    Arteb Brazil GMT400 headlight users thread

    Well I think I should make a post here. I can 100% agree with the sentiment of them being the best halogen housings available for these trucks. I know they were supposed to come pre-aligned but my passenger side one was way off so had to adjust it, but dialed in the low beams are great and the...
  10. C

    Arteb Headlights / Taillights End-of-Life (?)

    I appreciate this thread. If you do end up going for a bulk buy I'd like an additional set or 2 to have as spares, please keep us updated!
  11. C

    Wiring changes to suit ARTEB taillights

    Hey sorry for the late response, just logged back in for the first time in a while, I'll try to say what I can off of memory. So the 5 pin connector can be regularly found as it's been used in the Oldsmobile Alero and Pontiac Grand Am, if there's demand I'll start to stockpile these from...
  12. C

    What have you towed lately

    By weight, it was a Little over rated capacity, but that note on strapping it down, I'll hafta remember for next time, I have my own straps but never tried using it like a normal trailer lol
  13. C

    What have you towed lately

    Electric hatchback. Slightly overloaded her but she did the full 20 mile haul.
  14. C

    6 button A/C-Heater control hear for my '92.

    Any preference for black/gray colored? Just saw a few in my local pull a part yards I could snag
  15. C

    Rag Joint Delete Steering Shafts

    Hey @Cunningham Machine checking on the site it says that the black coated is sold out but trying to order it it says it's backorder, is it backordered or no longer available? And if it is backordered what's the ETA?
See more

Latest posts

Staff online

Members online

... and 7 more.
Total: 1,728 (members: 57, guests: 1,671)

Forum statistics

Threads
64,491
Messages
1,395,136
Members
51,812
Latest member
jealousy2500hd

Share this page

Top