Recent content by Billys44s
-
B
92 Chevy 1500 Stalls after 15 minutes of idling
Hey guys. I’m having an issue with my 92 Chevy truck, it has the 350 in it, the problem I’m having is I can start the truck up and let it run and it seems to run normal but after awhile it will just stalls usually after it warms ups but once it starts back up it seems fine. I had a issue...- Billys44s
- Thread
- Replies: 2
- Forum: Engine Performance + Maintenance
-
B
No park?
Hey guys. So I recently ran into a problem on a 92 Chevy truck. So a week a go my ignition module gave out on my truck and it was binding up and was letting my truck crank or lock into park. So I had to forcefully put the truck into park while I waited for a tow. And after getting the new one...- Billys44s
- Thread
- Replies: 3
- Forum: Transmissions
-
B
Pickup coil ohm test range?
Does anyone know the ohm range for the pickup coil? I’m trying to test my pickup coil in my 92 Chevy 350 and I got .840 in the 2k ohms setting and I think that’s test in range after you convert it over but I’m not sure if the range is the same as a hei pickup coil- Billys44s
- Thread
- Replies: 1
- Forum: Engine Performance + Maintenance
-
B
92 Chevy 350 hard starting/no start issue
The past few weeks my truck has been acting odd and I can’t seem to pinpoint what’s actually going on with it. I pulled codes off it a few times now and no luck I did get a code 54 that kept popping up but I’m unsure what it’s actually causing the code to appear. What been going on is I’m...- Billys44s
- Thread
- Replies: 1
- Forum: Engine Performance + Maintenance
-
B
Bucket seat interchangeably?
Hey guys. I have a 92 chevy 1500 ext cab and i was wondering what seats will interchange with it. It originally had the 60/40 split bench up front and i decide to change it out a few years ago to the bucket seat set up awhile back and the driver seat that i have now is so wore out it needs to...- Billys44s
- Thread
- Replies: 15
- Forum: OEM and Custom Interiors
-
B
Bed rails?
Hey guys Could anyone tell me what brand of bed rails these are? I been searching to find a set just like these but all i can pull up are the roundish style of rails, I really like these style of rails these were on my old truck and i sold that truck a good while ago- Billys44s
- Thread
- Replies: 4
- Forum: Paint / Body / Detailing
-
B
Mysterious connector?
I was recently doing some interior work on my 92 chevy 1500 and i happened to take the glove box out and seen this connector thats not plugged into anything, does anyone know what this goes too?- Billys44s
- Thread
- Replies: 3
- Forum: Wiring Diagrams
-
B
92 chevy 1500 extended cab 2wd ujoint?
Its a 4l60”700r4” the joints I tried that didn’t work was 352f and 534g im not sure what size caps I have because they where off of it before i got to it but i know that between the 2 u joints I mentioned they seem like they had the right caps for one side of the shaft and yoke but they wont go...- Billys44s
- Post #3
- Forum: Axles + Brakes
-
B
92 chevy 1500 extended cab 2wd ujoint?
Hey guys. My local oreillys is having a hard time figuring out what ujoint is supposed to go between the driveline from the transmission to the carrier bearing and to the one that goes to the bearing to the rear end does anyone know the correct part number for the proper ujoint? I think its the...- Billys44s
- Thread
- Replies: 3
- Forum: Axles + Brakes
-
B
Speed sensor help
I recently put a new transmission in my 92 chevy 1500 and before i parked it to do the swap my speedometer worked fine but after i swapped in it hasnt moved since, i have the harness for the sensor hooked up and i have the plug im assuming its for the lock up plugged up on the top of the...- Billys44s
- Thread
- Replies: 3
- Forum: Transmissions
-
B
Flexplate bolts clearances
I actually didnt know that, id figure if i ran it like that it would rub and id be back at square one,i ended up using my originals because they seemed less of a headache for me to deal with but thats good to know for the next time i have to do one of these- Billys44s
- Post #16
- Forum: Engine Performance + Maintenance
-
B
Flexplate bolts clearances
There weren’t the wrong bolts they sold me i tried both flexplate and flywheel bolts and they were still rubbing the crank, ive change a few flexplates and flywheel in the past and i never ran into this problem besides on this truck, my only theory is its was built in canada and ship to the us...- Billys44s
- Post #14
- Forum: Engine Performance + Maintenance
-
B
4l60 shift points
The original trans that came out of my truck had a big circle sensor and on it was a giant magnet but I didn’t see any gear pop out but i could of missed it with me being in a good rush to put the transmission in ill go take a look in the morning and see because its bugging the crap out of me...- Billys44s
- Post #6
- Forum: Transmissions
-
B
Flexplate bolts clearances
My factory bolts worked fine it was just the aftermarket bolts i had a problem with, it didn’t matter if i use a cheapy socket or a name brand it stick hit with the 11/16 head even with a open wrench the head of the bolt didnt clear but i ended up reusing all the factory bolts and put it back...- Billys44s
- Post #12
- Forum: Engine Performance + Maintenance
-
B
4l60 shift points
Hey guys, I recently got done swapping out my junk trans with a oreillys 4l60(700r4) on my 92 chevy and I wanted to know what its normal shifting rpm is supposed to be? My speedometer doesnt work after the swap idk if i missed something or not but i put new sensor into it and nothing happens...- Billys44s
- Thread
- Replies: 8
- Forum: Transmissions
