M
man-a-fre
Latest activity Postings About
-
-
MNot sure yet. I haven’t even been in my garage in a few days.. life is just too busy and I hate that. What if we just say **** working...
-
MJust FYI You can get the same functionality as the 1980-82 GM-2 & ABS GM-3 from the MT2500-90 Multi-1 The Multi-1 is easier too find as...
-
Mman-a-fre replied to the thread Confirmed brake bleeding scan tools.So will the mt2500 with this cartridge for sure cycle the isolation dump valve on a rwal 1994 k1500?
-
Mman-a-fre reacted to Erik the Awful's post in the thread Confirmed brake bleeding scan tools with
Like.
OTC 3210 added. Still no data on the aluminum RWAL nor EBC4. -
MOh yea, I’ll fire up the old brick tomorrow and see what menu options I get. I need to start a build thread I need to catch you guys up...
-
MLooks like it should work. Do you have a way of verifying?
-
MYes please!
-
MI have a MT2500 with a dedicated ABS cart. I’ll check to see if it can do the older RWAL systems.
-
Mman-a-fre replied to the thread What is a good o2 crosscount number for a 1994 350 tbi.Thank you Schurkey!
-
Mman-a-fre reacted to Schurkey's post in the thread What is a good o2 crosscount number for a 1994 350 tbi with Like.
Lowest number I saw on my '88 L05 was 6--8 at idle. 20+ at higher speed. Your truck is newer and has a heated sensor. 200 seems...
-
Mman-a-fre posted the thread What is a good o2 crosscount number for a 1994 350 tbi in Engine Performance + Maintenance.I was just wondering what is a very good closed loop heated o2 sensor crosscount numbers for a 1994 350 tbi k1500 and what would be a...
-
MOh Kay.... whatever was actually happening inside the starter...I heard it turning, but the drive wasn't engaging with the flexplate...
-
MOne of the problems on my Burb then, was that loose terminal. One of the others was that the starter was grungy and had oil in it, and...
-
Mman-a-fre replied to the thread Tbi distributor magnet protection from rust question.Thanks , I won't have to worry about that I have a new shaft and magnet I am installing in place of the old cracked magnet so I will...
-
Mman-a-fre reacted to Schurkey's post in the thread Tbi distributor magnet protection from rust question with Like.
There's no high-voltage in the pickup coil area. At cranking speed, it'll wiggle the needle on an analog voltmeter set to the 5-volt...
-
-
Loading…
-
Loading…
