Monty@taylormadetarp
Newbie
- Joined
- Dec 27, 2013
- Messages
- 7
- Reaction score
- 0
OK First Off Thanks for all the info in the forum. This is my first post
and really need info or so advise. I have a 97 crew cab 3500 7.4.. I use this truck to move my 5th wheel to Fl back to Oh.
on the way down my front cat was so hot it was making the floor smoke under the seat, I have not done any heat test or anything
but im sure it has stoped up , because last fall I put new muller back exhast week later I could her it rattling in the back cat.
Ok as most you gear heads know the factory replace cost around 900 bucks. I would like to clean them out No problems for me to pass inspection
because we have none.(The post is dragging on at this point) Will my puter run the truck or will it blow codes out the pipe all the time?
Any help advise anything im open to any help...
and really need info or so advise. I have a 97 crew cab 3500 7.4.. I use this truck to move my 5th wheel to Fl back to Oh.
on the way down my front cat was so hot it was making the floor smoke under the seat, I have not done any heat test or anything
but im sure it has stoped up , because last fall I put new muller back exhast week later I could her it rattling in the back cat.
Ok as most you gear heads know the factory replace cost around 900 bucks. I would like to clean them out No problems for me to pass inspection
because we have none.(The post is dragging on at this point) Will my puter run the truck or will it blow codes out the pipe all the time?
Any help advise anything im open to any help...