I've almost got the axle stripped down, just gotta get the knuckles off. I've been knocking on the screws with a hammer to knock em out but I've just been smushing the screws. I guess ima just get a bigger hammer.
I am now starting to build it up, but I have a few questions. So am I keeping the ford inner axle shaft, removing the ford outer axle shaft from the u-joint, and then putting a chevy one on it? And a stub shaft is the same thing as an outer shaft, correct? I'll have more questions in the future. For now, i have a few spots of rust on my ring that I am going to go try to get removed by the shop. Any good advice for me while I put this thing back together would be greatly appreciated!