I got a set of new heads for my truck from allied motor parts and they have xx one end of them how do I tell if they are square I put a framing square where the xx is and the end of the square was about an 1/16 off on the intake side is that bad
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Pictures wouldYou must be registered for see images attachYou must be registered for see images attach
I noticed that as I was tinkering around I was not going with the angle of the head where the intake mounts I think I was overly concerned and obsessed I went with the angle and the gap closed up to almost nothing
Calm down bruh, it ain't personal.Sure.no. pro,,,,blem y'al,l will never ha.ve to h,elp again a.,nd piss off with ,.your punctua,.tion bull ****