Ryhno
Newbie
Thanks. It needs a paint job and I’d like to bag it. I have to figure out front wheel tubs or something also, these wheels rub on real hard bumps.
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I finally got my truck converted to 6 lug and painted and installed my transport wheels.You must be registered for see images attachYou must be registered for see images attach
What size tire did you end up going with?I finally got my truck converted to 6 lug and painted and installed my transport wheels.You must be registered for see images attachYou must be registered for see images attach
I doubt it. 265s push over the bead a little on transports, 355 would rub like hell. Also in my experience a 35 is about as low a profile as you can get away with before you start bending these wheels on potholes.What size tire did you end up going with?
355/30r22?
I did, Moser axles and 6 lug stuff from Little Shop ManufacturingDid you do 6lug rotors and axles for your swap?
so to beat a dead post here. when you 6 lug converted it i assume you still have to run a spacer to make up for the difference in offset between gmt400 and 900?I did, Moser axles and 6 lug stuff from Little Shop Manufacturing
I don't think so. It sucks then in a little which is good for moar lowah.so to beat a dead post here. when you 6 lug converted it i assume you still have to run a spacer to make up for the difference in offset between gmt400 and 900?