Search results
-
A
Body Mount Question
In the process of installing Poly body mounts. The large metal washers that go on the bottom of the mount have stamped numbers as follows: A5, B5, A4, etc.... Can anyone tell me which one goes where? I didn't pay attention when I removed them. My truck is a 95 ECSB for reference.- axisT6
- Thread
- Replies: 1
- Forum: Stock Suspension + Bolt On Kits
-
A
2WD --> 4WD SAS --> 2WD SAS...Axis' Truck Saga
My truck started life as a simple 1995 Chevy ECSB with a 305 V8, 4L60E, and 10 bolt rear. I then got bit by the mod bug. Here is the truck with Fabtech 4" Spindles, 2" coils, add-a-leaf/block in the rear, 4.10s, and Auburn Posi on 285s... I then discovered that with this same lift, I...- axisT6
- Thread
- Replies: 12
- Forum: Full Custom Suspension / Cages / Fab
-
A
MEASUREMENT REQUEST: 2WD Frame Clearance with Long Tube Headers
I straight axled my 2wd and would like to see if I can clear my leafspring brackets with longtube headers. My brackets stick out roughly 6.5" from the frame rail. I am hoping that 2WD GMT400 longtubes are position closer to the center of the vehicle than 4WD trucks. If you have a 2WD with...- axisT6
- Thread
- Replies: 7
- Forum: Engine Performance + Maintenance
-
A
Engine Knocks at 2500 RPM Regardless of Load
I will give specifics first. The truck is a 1995 ECSB half ton with a TBI 305. It has the ultimate TBI mods, a mild tune, and has been converted to a manual trans. When I did the tranny conversion I also burned a chip so the ECM (16197427) would not longer look for an auto. I basically put...- axisT6
- Thread
- Replies: 8
- Forum: Engine Performance + Maintenance
-
A
Pic Request - 2WD Trucks with Long Tube Headers
I searched, but couldn't find what I needed. For those with 2wds that have longtubes, could you give me a measurement of the gap between the collectors (part where the primaries join) and the chassis? I am thinking of re-doing the SAS brackets on my truck and want to see if I can clear long...
