Search results

  1. M

    1999 CCSB drive line vibration after lift

    I put a RCD 6 inch lift in my truck and I have a slight vibration on takeoff. I also feel a vibration in my feet through the floors while doing highway speeds. I just had the drive shaft rebuilt with new u joints and a new carrier bearing. Also had it balanced. The shop told me it was a...
  2. M

    Gooseneck Pictures

    Who here uses a gooseneck and what kind? Lets see some pictures?
  3. M

    1999 Vortec 7400 injector swap

    i upgraded the injectors on my 1999 GMC 7.4 from the factory one to the ls1 injectors. Truck runs good now. but I now have a SES light on. I have a p0172-p0175. Both rich codes. I assume its because I have bigged injectors. I was under the impression from all that I read here that it...
  4. M

    1999 Vortec 454 Rough idle

    Having a hell of a time figuring this out. My truck has had this rough idle since I bought it. It idles rough and stumbles until it gets about 1500-2000 rpm. No engine codes are stored. It did have a hard time starting and backfired a little a few times but it hasnt done that again. It...
  5. M

    Re installing Torsion Bars

    OK guys....So I am installing a 6 inch RCD lift kit on my 1999 K2500.....Had some issues with the driver side spindle not fitting and RCD had to get me a new one.... The problem I have is the truck has been sitting on Jack stands in my drivway for 6 weeks while I was jerking around with the...
  6. M

    RCD Lift Kits

    Anyone have a RCD lift kit in there trucks? Specifically a 88-2000 2500 or 3500? Looking to pick your brain.
  7. M

    1999 Vortec 454 Running rough and drivning me nuts

    My 1999 GMC ccsb is running pretty rough. I have already done plugs, wire, cap, and rotor. I have also done the FPR. The previous owner said the injectors were done but im not entirely sure they were. They looked a bit rusty when I had the intake of to do the regulator. He also told me he...
  8. M

    8 lug wheel spacers

    I need a set of 8 lug wheel spacers for the rear or my truck. Trying to even out the rear with the front. Who makes a good set? I tow with my truck and it sees logging roads a lot. They need to be strong. Any suggestions?
  9. M

    Are there any steering upgrades out there?

    I am looking to beef up the front end of my truck. Its a 1999 CCSB 2500. I have seen the cognito stuff. Are there any other upgrades out there for these trucks? I just orderd a RCD lift kit for it so they would have to work with the lift.
  10. M

    Vortec 7400 rough idle

    Just bought a 1999 GMC 2500 Crew Cab Short Box with the 454. The truck has about 90,000 miles on it. When driving it home I noticed a slight rough idle that I didnt notice on the test drive. It drives down the road fine and doesnt hessitate or stumble. Its not really bad but you can feel...
  11. M

    Anyone ever do a ram air setup?

    I have a 1999 2door Tahoe and I have probably every bolt on mod you can do it....I was wondering if anyone has done ram air on these trucks before.

Latest posts

Staff online

Members online

... and 4 more.
Total: 1,543 (members: 54, guests: 1,489)

Forum statistics

Threads
64,550
Messages
1,396,351
Members
51,974
Latest member
billmack7

Share this page

Top