Search results

  1. M

    C5 Wheels on 2/4 Dropped SCSB

    Has anyone here seen this done? I may end up going lower if I get the wheels but I wanted to see what they looked like before going forward with it.
  2. M

    Brake switch getting hot blowing fuses, signals clicking

    I have a weird one, my turn signal relay was clicking without the signals or hazards on. The hazards and blinkers still work, they turn on and off as they should, but the clicking noise from the relay doesn't stop. I pulled the signal relay, and the relay's outer cover was melted. Replaced...
  3. M

    Shimming Carrier Bearings for Backlash, How Much?

    I'm putting an Auburn limited slip in my gm 8.5" (3.42 ratio) and my backlash is currently 0.015" (too wide, ), looking to get it between 0.005-0.009". Is there a rule of thumb for how much shim I shift from the left to right to how much backlash I will reduce? I have a shim set with 6...
  4. M

    Turn Signals Work But Flasher Relay Continues to Tick

    Anyone encounter this issue? The signals and emergency flashers come on and off as they should but the relay continues to tick as if they didnt turn off. Ive replaced the signal relay and the new one does it too, the old one shows signs of heat as the relay outer cover was melted.
  5. M

    96 Vortec Timing Question

    Anyone know of a reasonably priced programmer that can set the timing offset on a vortec 350? i hate spending $100 every time i have the motor apart.
  6. M

    Motor Mounts on 350 Small Block

    Well, I have my motor back in the truck and got to talking with some guys at work who strongly suggested I change my motor mounts while the motor is still loose. Does anyone on here have a how to video or tips/tricks to getting these things off with the motor in the truck? It's a 96 v8 c1500...
  7. M

    NV3500 38t Reverse Gear Seal

    So there is a seal that's pressed into the back side of the reverse gear on the nv3500 output shaft. It's missing from every part diagram Ive seen... I bought a new reverse gear and it wasn't included, any idea why it's there? It's in the middle of the output shaft internal to the transmission.
  8. M

    3d Printed Emblem

    First stab at a DIY emblem. What do you think
  9. M

    305 vortec to 350 crate motor swap exhaust question

    I just bought a crate 350 vortec, going from a 305, and was wondering what all i need to do wih the single cat setup from the 305, will it run with the 305 y piped exhaust? Do i need to swap the pcm for a 350?
  10. M

    Crate vortec 350, 390hp question

    I'm looking to put in a crate motor and came across this, does anyone have any experience with this motor? What all would i need to get it reliable? I have a 305 vortec in the 96 1500 truck now. https://paceperformance.com/i-23869...t-main-no-mechanical-fuel-pump-provision.html Id like to use...

Latest posts

Members online

Total: 1,063 (members: 9, guests: 1,054)

Forum statistics

Threads
64,393
Messages
1,393,034
Members
51,568
Latest member
SirTurdFerguson

Share this page

Top