Rock Hard Concrete's latest activity
-
Rock Hard Concrete reacted to Erik the Awful's post in the thread Nv3500/5lm60 cracked case with
Like.
I'm a cheap basturd, and it's definitely worth the time and/or money. You know somebody who can weld. Ask around. Where are you located... -
I can confirm that Rotella T6 15-40 does not foam at motorcycle RPM. Used it for years.
-
Rock Hard Concrete replied to the thread Oil Question.Running a heavier gear oil will not hurt anything. Use any multi weight engine oil that ends in 30 or 40. Synthetics last longer...
-
The other thing to consider, is that after you drive the truck around for a while and the rear leaf springs are jounced, they will...
-
Rock Hard Concrete replied to the thread Manual transmission ratios.All full sized gm trucks got the wide ratio nv3500. You should have good results by regearing if you didn't want to have to find a new...
-
Rock Hard Concrete replied to the thread Airbag Went Off.An airbag going off randomly is a huge issue. Like, lawsuit and lawyers huge issue. It doesn't matter if a vehicle is older than...
-
if it was me I would disconnect the battery and pull the air bag fuse to make shore that the drivers air bag dose not randomly go off
-
Rock Hard Concrete reacted to Nad_Yvalhosert's post in the thread Alignment Cam Bolts 1990 C1500 Drop Spindles with Like.
Please please please DO NOT BUTCHER the adjuster tabs with an air tool. Just reassemble, send it to the alignment shop and let the...
-
Rock Hard Concrete reacted to Drunkcanuk's post in the thread Alignment Cam Bolts 1990 C1500 Drop Spindles with Like.
One of mine knocked out easily, the other not so much. But I got it after a 10min struggle and nasty words. Mine came with new cams so...
-
Rock Hard Concrete reacted to someotherguy's post in the thread Alignment Cam Bolts 1990 C1500 Drop Spindles with Like.
Seems they have varying degrees of difficulty on removal. I've got to do them on my '93 C3500 at some point when I get around to...
-
Rock Hard Concrete replied to the thread Alignment Cam Bolts 1990 C1500 Drop Spindles.I very much recommend an air chisel. When I rebuilt the entire front end on my 1990 c1500, those knockout tabs took me HOURS. One side...
-
Rock Hard Concrete replied to the thread Long bed to short bed conversion with pics.You can learn a lot about a person by their preference of truck bed.
-
Another vote for the Yokohama Geolander G015. I'm on my 3rd set with different vehicles. Best overall A/T I've found for quiet on the...
-
1000cca battery from Walmart or Costco. Take it back every 3 years before the warranty is up and get a new one. Do it in the parking...
-
I've killed a couple AGM's before I switched back to standard due to the cost of the batteries. And I can 'rejuvenate' standard...
