Recent content by Paul Haring

  1. P

    Installing component speakers

    So take wires from the mid to power crossover? Then make wires to mid and tweeter from crossover? What gauge speaker wire should I purchase?
  2. P

    Installing component speakers

    Ok. Thanks for the help. Any way to run Bluetooth to stock headunit? Looking a at Kenwood excelon headunit
  3. P

    Installing component speakers

    I am looking to replace speakers in 97 k1500 Evan. Have factory door speakers with tweeters. Have never wired components before. Do I use factory wire to the crossover? Saw on video that something needs to be removed. Don’t want to ruin new speakers or headunit. Looking to use infinity...
  4. P

    Body mounts

    I know this is an older thread, where did you purchase the rubber mounts? Part #? Also what is the torque on the bolts? I hve nerf bars connected to mine and they seem loose.
  5. P

    Looking to build F44 suspension

    Ok. Thanks for the info.
  6. P

    Looking to build F44 suspension

    Great guys. Thanks for the help. Should be good to go with 1/2 ton Bilsteins.
  7. P

    Looking to build F44 suspension

    Ok thanks, How does your truck ride with that spring pack?
  8. P

    Looking to build F44 suspension

    How does your truck ride with the 3/4 ton spring pack?
  9. P

    Looking to build F44 suspension

    I was thinking c2500 as an in between. I figured K2500 would be larger spring pack.
  10. P

    Looking to build F44 suspension

    When I look them up on Bilstein catalog I get different numbers for k1500, c2500, and k2500 shocks. All 4600 models. Not sure which to use.
  11. P

    Looking to build F44 suspension

    I have the right 14 bolt rear. What is everyone running for shocks? I am looking to go the Bilstein route. I notice people say the ld 3/4 ton spring gives them approximately 2" of lift. I would think half ton shocks might be short. Looking for suggestions and what you guys with F44 setup...
Top