So I too have this issue with 1 of my trucks I ironically tore the whole dash apart looking for a relay that wasn't even there I swapped out fuses I looked for broken wires quite literally I don't get power at the actuater so I'm very frustrated
I believe if you remove the Rev limiter and keep it stock you can really only hit 6500 rpm anything after that your going to have some real issues with lifter float I'd think
well considering i have short hooker headers going to 3 inch straight pipe and naturally aspirated I'd say I'd have alot to gain upgrading to port polished heads and 1.6 rockers and a good tune
So last question I had is it a good idea to go a bit overkill on valve springs as far as what I can put in for lift because I wanted to go with something like a stage 2 where my max lift would be about .495/.503 for the cam I want or should I wait till I have everything to put together
I didn't need a huge lift of 4-6" which is y I went with a leveling kit yes I know it's horrible as far as alignment and replacing parts but the old girl doesn't get alot of road time as my other truck gets way better gas mileage but when I do Need it it's usually to haul wood over really rough...
I want more power out of my 96 350 but don't want to pull the motor to do so if I don't have to as I dropped it in less then 6 months ago. Whipping shities on frozen lake lmao. But I have the heads from the old motor I already had them pocket ported and polished I'm trying to upgrade my valve...
You might be pushing to many volts to the sensor you could have a bad ground going to the maf it could be getting dirty so I'd check your air filter especially if you take alot of gravel but I'd inspect the wires and use a multi meter to test voltage it should have a 5 volts going to it if I...
Yes if the cargo light switch is of it shouldn't have any voltage at the light you'll have to pull the headlight switch and see if there is a jump wire running to your cargo light that or you could be back feeding through a ground wire best of luck.
Hey guys looking for advice I put in a leveling kit and they included tortion keys I put them in and wouldn't you know it I need different arm they are hitting the shock stop on the frame looking for an upper control arm to handle the leveling kit haven't had much luck online