Recent content by Bburban94

  1. Bburban94

    DIPstick install

    Thanks rich I ordered a grommet engine install was going so nice till a saw a floppy dip stick tube
  2. Bburban94

    DIPstick install

    I was in a rush better ones soon is it just a grommet and it pushes in
  3. Bburban94

    DIPstick install

    How do install the trans dipstick on a 94 suburban
  4. Bburban94

    Tbi rockers and push rod questions

    These are the heads I bought are these the non self aligning heads if so can I still use them they are also stamped 193
  5. Bburban94

    Tbi rockers and push rod questions

    These are my old heads that I pulled off my old motor they are clearly stamped 193
  6. Bburban94

    Tbi rockers and push rod questions

    The heads I bought are cast 193 tbi heads
  7. Bburban94

    Tbi rockers and push rod questions

    I bought some used heads but they didn't come with rocker arms or push rods i was wondering if I could swap my rockers and rods off my old tbi heads to my bare head what would be the process
  8. Bburban94

    What carb is this its two barrel i thought that 350's in 82' had Quadrajet

  9. Bburban94

    Can you put an 82' 350 in where a 94 350 was

    Thanks guys I think I finally got a good ideas about how to go about this I will update later or if I have any more questions
  10. Bburban94

    Can you put an 82' 350 in where a 94 350 was

    Thanks you guys alot also where could I find the flexplate to crankshaft bolts and are there 7 of them?
  11. Bburban94

    Can you put an 82' 350 in where a 94 350 was

    So can I put the tbi heads on then the tbi manifold considering the manifold bolts in to the tbi head the angle for the bolts should not be a problem because the manifold is on a tbi head
  12. Bburban94

    Can you put an 82' 350 in where a 94 350 was

    Can I put my tbi heads on this block
  13. Bburban94

    Can you put an 82' 350 in where a 94 350 was

    Ok thank you so much another question the bellhousing bolts should all be in the same location right and should my accessory drive brackets bolt up on 82' just like my 94'?
  14. Bburban94

    Can you put an 82' 350 in where a 94 350 was

    Can I not put my intake manifold with my tbi unit inplace of the carb and intake it sits on I have all of the parts I took off my tbi motor
  15. Bburban94

    350 Tbi hesitation when accelerating.

    Check all your grounds my suburban did the same thing truns out it was my engine to frame ground had rotted away
See more

Latest posts

Staff online

Members online

... and 17 more.
Total: 1,844 (members: 67, guests: 1,777)

Forum statistics

Threads
64,486
Messages
1,394,908
Members
51,776
Latest member
Fozbrick44

Share this page

Top