Recent content by adb5274.ab

  1. A

    Rear Axle "Repair" Bearing, anyone use these???

    So I replaced rear axle bearings and seals in my k1500 because the one was leaking with the original replacement bearings/seals. I did not see any visual damage to the axle shaft when replacing the bearings but the same one that was leaking before, is leaking again. I seen the rear axle "Repair"...
  2. A

    Just Got My RCSB Done!

    Thanks! I got the interior semi tore apart until I get finished routing the amp wires, also got the shifter boot to bolt down yet. But as soon as I get everything wrapped up ill post up a pic. The interior is beautiful in this truck though. looks like it never had a stain in it, very well kept...
  3. A

    Just Got My RCSB Done!

    Here's my 94 RCSB I been building for the past two months! Started out as a totally stock two tone red/silver one owner truck. I bought it from the older gentleman for a great price. It needed a lot of body work and such but now its done! Picked up the lift used, put hooker headers on it...
  4. A

    94 Chevy Brake Switch Not Engaging

    yep probably right hah
  5. A

    94 Chevy Brake Switch Not Engaging

    94 Chevy k1500 Brake switch only engages when I manually pull up on the switch assembly. When the brake pedal is pressed down, the brake switch slides down the booster shaft but does not make the contacts within the switch unless I pull on the switch to engage it all the way. Just got the...
  6. A

    tbi chevy barely starts, runs very rich

    scratch that, when i put everything back together after getting the ignition module checked i had all the plug wires rotated clock wise one to many! my dumb fualt, so not sure if it was the cts or map but if anyones interested im goin to be takin the map back off to see if it really was the cts...
  7. A

    tbi chevy barely starts, runs very rich

    well the cts and map didnt work. i ohmed out the pickup coil before i put the ignition module nd cap back on. the two pins ohmed out infinity nd ive read they are suposed to be inbetween 500 to 1500 ohms. i put everything back together anyway and tried the cts nd map which didnt work. checked...
  8. A

    tbi chevy barely starts, runs very rich

    just ordered a new CTS, MAP, and a tbi rebuild kit. gonna pick them up afterwork and try them in that order. based on the info i gathered and yous gave me i don't believe its the fuel pressure regulator but would mind rebuilding the tbi, cleaning it and doing the tbi mods anyway down the road...
  9. A

    tbi chevy barely starts, runs very rich

    I ohmed it out a few weeks ago I believe it was some where in this area 2238 ohms @ 86 deg. F. or 30 deg. C. 2796 ohms @ 77 deg. F. or 25 deg. C. assuming these are accurate then the CTS should be good but I can check it again. any way the fuel pressure regulator would cause a flooding...
  10. A

    tbi chevy barely starts, runs very rich

    I don't hold it to the floor, just pump it very quickly, always seemed to be the trick with troublesome carbed motors, just kinda stuck with me I guess. anyways it is def flooded. would a bad pick up coil be a some what intermitted problem or would it fail completely? im trying to get a game...
  11. A

    tbi chevy barely starts, runs very rich

    would a bad fuel pressure regulator cause these conditions??
  12. A

    tbi chevy barely starts, runs very rich

    it stumbles and trys to start when the gas is pumped alot from in the cab but floods bad so im assuming its getting spark. im new to these tbi's but acts like a carbed motor thats out of time but i dont know how it would got so outa time, ran fine before i parked it. i just got the ignition...
  13. A

    tbi chevy barely starts, runs very rich

    94 tbi 5.7 been buildin this truck for a few months replaced: plugs, wires, cap, rotor, pcv valve full length headers, dual exhaust, cat delete fuel pump and tank cleaned all grounds swapped auto out for 5 speed now the truck pretty much wont start. will kinda try to start when...
  14. A

    1990 350 tbi running super rich help

    my 94 ran the same way after I put full length headers on it before I ran the rest of the exhaust. I could barely keep it running, then threw the first couple feet of the exhaust on it and it ran good enough to move it around, def improved. I think with the long tubes and no exhaust theres not...
  15. A

    What Offset Wheel on lifted Chevy? Please Help!

    I don't know where to post this but can anybody help me pick a wheel offset for my obs?! I have a 94 Chevy 4x4 1500 rcsb that I am just about finished with and am about to order new wheels and tires for. The truck has a 6in bracket lift and 3in body. I am looking to order 35x12.5x20 tires but...
See more

Latest posts

Members online

Total: 1,489 (members: 42, guests: 1,447)

Forum statistics

Threads
64,672
Messages
1,398,408
Members
52,199
Latest member
NickArchibald1994

Share this page

Top