Bertha1996
Newbie
I have read just about all of the posts and followed there steps and nothing has worked.
I just rebuilt my stock 350 Motor from a 1996 Chevy k1500 with a manual transmission and when I reinstalled the motor and attached all of my electrical back up but now I have no spark coming out of the ignition coil I have tested the connector for power and 1 pin has 12 volts and the ICM has power too but When I crank the motor it turns but there is no spark and the crank position sensor gives no feed back with a scanner hooked up
I have replaced the ignition coil and the ICM still no spark and I’ve been checking what I think is all of my ground cables unless I’m missing one I can’t seem to find anything that would cause no spark like that and cause the crank position sensor to not read either any help would be appreciated because I’ve been at this for 3 days and have gotten nowhere
I just rebuilt my stock 350 Motor from a 1996 Chevy k1500 with a manual transmission and when I reinstalled the motor and attached all of my electrical back up but now I have no spark coming out of the ignition coil I have tested the connector for power and 1 pin has 12 volts and the ICM has power too but When I crank the motor it turns but there is no spark and the crank position sensor gives no feed back with a scanner hooked up
I have replaced the ignition coil and the ICM still no spark and I’ve been checking what I think is all of my ground cables unless I’m missing one I can’t seem to find anything that would cause no spark like that and cause the crank position sensor to not read either any help would be appreciated because I’ve been at this for 3 days and have gotten nowhere