My 95 Burban

[Sierra]

how did you take the pins out of the rear doors? I need to replace the driver side barn door on my 95 burb.

 

[91Bluestreak]

I cut the pin with a cutoff wheel and then I was able to puond them out of the hinge on the driver side but the pass side I drilled them out. I still have to remove the pins from the parts truck doors.

 

[91Bluestreak]

hung the doors temp and pulled her outside.
Doors fit nice minus not having bushings in the front ones.

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

this one just because I hate Toys

You must be registered for see images attach

 

[TylerZ281500]

whatd you do with the SAS'd burban? cant believe i just found this thread too.

 

[91Bluestreak]

I sent it to scrap after I got everything I needed off of it.

 

[West Mi Mudder]

Yeah, i hadnt seen this thread either. Looking perdy good!

 

[TylerZ281500]

boo i wouldve taken stuff of it if you wanted to sell stuff. whats next for the build?

 

[91Bluestreak]

there wasnt much left of it, I cut the quaters and rockers off for patch panels. Pulled all doors, rear axle, interior, and front clip.

 

[91Bluestreak]

not much is going on with the burban until the pickup is fixed. Then I need to finish the rust repair and interior, then paint.

 

[TylerZ281500]

still was sas'd wasnt it? and woohoo for body work i need to sttart mine sometime but just dont have the motivation.