Hi Im not sure if this is the right thread or not but here goes.
I have a 1998 chevy k2500 4x4 (no lift) and am currently in the process of rebuilding the all the front end steering components at about 150xxx miles. I plan on reusing my upper control arms and having a shop remove and press in new bushings and balljoints (they said they could do this for both the uppers and lowers for $45 total). As for my lower control arms, I wanted to swap the welded ones out for a set of the stock forged ones from a junkyard and do the same thing. My local junkyard has a set of lower forged control arms out of a 1999 k2500 4x4 they would sell for $50 and I just wanted to ask on here and make sure these new used lower control arms will fit. Thanks for any responses.
I have a 1998 chevy k2500 4x4 (no lift) and am currently in the process of rebuilding the all the front end steering components at about 150xxx miles. I plan on reusing my upper control arms and having a shop remove and press in new bushings and balljoints (they said they could do this for both the uppers and lowers for $45 total). As for my lower control arms, I wanted to swap the welded ones out for a set of the stock forged ones from a junkyard and do the same thing. My local junkyard has a set of lower forged control arms out of a 1999 k2500 4x4 they would sell for $50 and I just wanted to ask on here and make sure these new used lower control arms will fit. Thanks for any responses.