Search results

  1. Z Long Bed

    88 3500 4x4 7.4 10k miles WIW?

    Found a 1988 3500 RC long bed, 4x4 with the 454 and only 10,000 miles. What would this be worth approximately? I would drive as is, and/or do a complete swap into my 95.
  2. Z Long Bed

    Amber cab lights and harness

    Looking for the factory (roof) cab lights and harness. If anyone is making a harness for this I would go that route as well. Thanks.......
  3. Z Long Bed

    95 Trans snapped. What options?

    I just trashed the trans on my 95 Silverado 1500. Pulling away from a red light and it just snapped, and didnt move at all. Its got 1 rebuild on it. Now at 357,000 miles. What options do I have for a replacement? Rebuild/replace the 4L60e? Will a 4L80e be a direct replacement without other...
  4. Z Long Bed

    Stiffen truck bed sides?

    Kind of off the wall thought here.. My truck is in really great shape, though I do use it as a truck. Over the years, the sides of the truck bed have developed a few slight dents. This is most likely from leaning over the bed sides to place or retrive items in the bed. So, if I were replace or...
  5. Z Long Bed

    1995 Silverado Z71 Extended Cab Long Bed LWB 2 Ton dump Fleetside

    I had this on Craigslist, but it kept getting flagged. $5,000 OBO 1995 Chevy Silverado Extended cab with 8 foot bed K1500 ( K 2500 door emblem) I have owned this truck for over 15 years. It spent several years in Delaware and the past 7 years in Tennessee. It has had limited driving in Iowa...
  6. Z Long Bed

    1998 2500 Silverado Long Bed Ext cab 89,000 miles

    Not my truck--Not my listing California clean Iowa truck! 89,000 miles. Long bed, extended cab, 4x4 Silverado with the 454. Has gray split bench. Full DeeZee runing boards, topper and solid push bar. I looked at and drove this truck last week. If it had tan buckets, cab lights and the third...
  7. Z Long Bed

    Hellwig rear swaybar

    Has anyone used the Hellwig rear sway bar on their GMT400? Can't quit figure out how everything mounts from the picture. The main bar to the rear is simple enough. I' away from my garage for a while and don't want to weld anything. Plus I just detailed my frame...
  8. Z Long Bed

    Best crate engine?

    Looking to drop in a crate engine to replace my 1995 5.7 TBI. My original engine has 333,333 miles, doesn't knock, smoke or ping. But, I know it's just a matter of time before something goes. I do tow a bit and would like a little more power. I want a reliable drop in engine with no LS/ big...
  9. Z Long Bed

    New front end for Z Long Bed

    It'll be coming together this week. Everything is MOOG where possible. Will be installing the following: Redhead steering box Addco sway bar, bushings and end links OEM blasted and powdercoated A arms and steering knuckles upper and lower control arm bushings upper and lower ball joints inner...
  10. Z Long Bed

    275/70/18's on factory NBS 18" wheels with no lift

    Here is how they fit. Factory 2010 Silverado wheels with Goodyear DuraTrac 275/70/18 tires. Nothing hits, though I may trim the front valance to be safe. I don't think I could have gone any bigger without trouble. I tried finding a post before I bought these, so I thought I'd let you all know...
  11. Z Long Bed

    Heater blows but doesn't always come out vent/floors. fogs windows. Defrost is ok

    I did try to search but didn't see anything. So it seems as though when I switch the controls from defrost to vent, sometimes the fan doesn't divert to the vent position. The blower sound gets louder, but no air comes out. The defrost seems to work ok. Sometimes it diverts ok and the heater...
  12. Z Long Bed

    NOS top cover for rear bumper $50., gray center consol $25 all plus shipping

    Couldn't locate my pictures so attached the ad...hope that's ok.. http://knoxville.craigslist.org/pts/4585716262.html http://knoxville.craigslist.org/pts/4585689567.html
  13. Z Long Bed

    New SSBC calipers and rotors installed 95 Ext long bed Z71

    Just installed a set of SSBC front duel piston calipers and slotted rotors on my 95 Z71. They seem to really grab nicely even though my rear brakes are shot and have a leaking wheel cylinder. My old brakes gouged my rotors before I could get them replaced, so this was a prime opportunity for...
  14. Z Long Bed

    Factory fog light switch how many wires do I need to use?

    How many wires do I need to use on a factory fog light switch? I'm about to install a pair of fog lights and would like to use a factory fog light switch. The switch that came with the lights has 3 wires. BTW, I'm looking for a factory switch to use since I don't have one yet. Thanks for...
  15. Z Long Bed

    1997 Sierra 4 door long bed 4x4 56K miles 454 $8,000 in MASS, not mine

    This is really close to what I've been looking for but was too far for me to go to look at. If it was a 1/2 ton short bed, 4 door, I would have taken a little plane ride. I contacted the seller about the reserve..... Unless he sole it after the auction, it should still be available...
  16. Z Long Bed

    WTB K1500 upper and lower control arms

    Looking for good clean upper and lower control arms for my K1500 Silveradao. I plan on having them blasted and powder coated before my front end comes apart for the rebuild. Interesed in any other small parts that could be powder coated on the front end at the same time too...sway bar if not...
  17. Z Long Bed

    Dash mounted switch plate custom fit.

    Dash mounted switch plate. $25 plus shipping. I pulled this from another truck and have not had it hooked up myself.
  18. Z Long Bed

    looking for best replacement heater core

    There are signs that my heater core is nearing the end of its useful life. The GM original has lasted 292,000 miles. I've looked at the local parts stores and they are all made in China. I have not check NAPA yet.... Does anyone know of a heater core NOT made in China? Made in U.S.A. would...
  19. Z Long Bed

    Where to buy brake lines for Long Bed Ext Cab

    I want to replace all of my brake lines and cant seem to locate the correct kit. I'd rather not bend my own. Summit lists them for long bed or extended cab.... Would these be the same as the Suburban? I've search these forums and have only come up with more upgrades I need to add to my list:hmm:
  20. Z Long Bed

    Low beams go off when tilt wheel is raised!! Need a little help please..

    Headlights work fine until I tilt the steering column up, then the lights go OFF. When I tilt the column down they come back on. With the high beams on there is no issue, I can move the column up, down and the lights stay on. The column is still pretty tight........ I've seen a couple...
  21. Z Long Bed

    Is the Vortec exhaust manifold the same as TBI manifold?

    My truck has an exhaust leak due to a bad exaust manifold. The 2 studs off the back of the manifold are preaty much rusted off. Rather rather than pull the old one off, try to repair it, then reinstall, I would like to swap out with a like new manifold from a 99 Tahoe that had a Vortec engine...
  22. Z Long Bed

    Stock switches mounted on the dash

    It looks like there are a few more places to mount switches on the dash of my 95. I only have the 1 switch for the cargo light. What were some other switches that were placed on the dash panel? I've seen the Tahos had a wiper switch...what else? I've thought about adding switches, but would...
  23. Z Long Bed

    Z upgrades

    Replaced the grill, lights etc and installed a diesel bumper. Started the temp/compass install today. I have a hood scoop project in the works...it'll be a little different.. New style 18" wheels.
  24. Z Long Bed

    Tail lights extra plug. what is it exactly?

    I found 3 tail lights in the yard today. The ones off a 99 Tahoe had the regular plug (which I used) and another pair of wires above this going to another light or something. What exaclty is this for? Thanks...
  25. Z Long Bed

    Power mirrors quit working

    Need a little help. My remote outside mirrors quit working. The fuse is good and I've tried replacing the switch, and still nothing. I have power to at least 1 wire to the switch, but that could be just the light. Any ideas on what to check next? Thanks,

Latest posts

Staff online

Members online

Total: 1,534 (members: 38, guests: 1,496)

Forum statistics

Threads
64,476
Messages
1,394,724
Members
51,754
Latest member
Riccoon

Share this page

Top