Thanks for the reply, man I really thought someone posted regarding the 8lug. I need to improve the front brakes, I am going to try the NBS master cylinder with my OBS Hydroboost setup. I am going with a slotted rotor and EBC pads, anyone have any other recommendations for the front? I already...
Hey guys,
I read one of the many OBS brake threads that talks about upgrade my Burb's 4x4 8 lug 8600lb front brakes to the larger caliper found on the 3500's but now of course cant seem to find the thread.
I just need the parts list for the year/model of
Rotor:
Caliper:
Pads:
I want...
Hey guys,
I've rebuilt my front end and there is still slop in the steering, so I'm going to do it right and put a new box in, what should I go with?
Also, If anyone has a link to the write up that uses the metal Jeep style steering shaft that replaces the rag joint with U'joints let me...
Problem sovled!
I feel very relieved but also DUMB for overlooking the obvious...
I took the diff pan off and drained the fluid, looked clean and smelled fine.
No metal parts in the bottom of the pumkin and all gears looked in tact...
Since both rear tires were off the ground, I decided to...
G80? It has the 14 bolt FF and 4L80e transmission
Yes to the hydroboost, I'll check that...didn't think about that.
Thanks guys,
Any input is appreciated :D
Hey guys,
My truck is a 2500 Burb with 7.4l and 80 series tranny and 14bolt FF rear end.
My rear brakes have needed to be adjusted for a bit and has caused a pulling effect to the drivers side under hard braking...today that became more noticable when I drove my truck from its parking...
sorry for late reply,
265/70 or 75/16
slightly larger than stock....but not by much.
for searching purposes, regarding the NBS:
2002 suburban hydroboost master cylinder
OBS hydroboost unit
OBS unit must be machined to accept the NBS MC...takes slack out of pedal and engages the...
No guys, the opening in the OBS hydro boost is too small to accept the bore of the NBS master cylinder. So what has to be done is the OBS booster needs to be machined another 1/4" bigger.
My question is if anyone knows the best tool for the job?
I think I've decided to just buy the OBS...
anybody use the NBS master cylinder with the OBS hydroboost? I've heard that makes a huge upgrade in pedal feel but the MC is too big for the opening in the OBS booster?
Heres a good thread to follow regarding the NBS master cylinder upgrade for the OBS hydroboost.
http://www.fullsizechevy.com/forum/general-discussion/technical-maintenance/418811-answer-squishy-obs-brakes-perhaps.html
Hey guys,
I just got back from a camping trip this weekend and had a near collision occur on the freeway because my brakes wouldn't stop my burb at a reasonable rate. I was driving 65mph and kept a reasonable distance in front of me but it still wasn't enough so I had to jump on the brakes...
Sorry, it's for the transfer case... Not sure which model. It's a
Recessed hex bolt, like an Allen head. I'm going to try a 7/16 or 10mm but
Kragen doesn't have it so have to drive to sears