Recent content by Blind

  1. Blind

    1996 Tahoe sport z71 2 door in SoCal - $8500

    http://www.ebay.com/itm/171251274523?forcerRptr=true&item=171251274523&viewitem=&sspagename=ADME:L:LCA:MOTORS:1123 Not sure if this is allowed here, move or delete as needed.
  2. Blind

    How did Stock Offroading work for you?

    my 2dr tahoe is a bit of a beast off-road even stock, unless the trail is too narrow (meant for quads or bikes) or just large rock piles. I stay away from the rock piles as I don't want to risk the body damage. Pretty much as long as the tires are touching the ground it will go up or down it. I...
  3. Blind

    Bearings or New Engine?

    mine cracked a head at ~118k miles, I replaced both heads and everything above them, then at ~123k miles going down the freeway the trans lost 3rd + 4th gear and then the engine stalled while holding 55mph in 2nd gear...totally ***** the rear main bearing when it locked up tight like that...
  4. Blind

    Not much air out of vents

    Having just dropped in a new motor, I went through and replaced all of the components of the a/c system and had it all charged it, it blows nice and cold in the 30's out of the vents now. However it takes a LONG time to cool down the inside of the truck on a hot day, like rediculously long...
  5. Blind

    I've never seen this before...

    yep, factory. It didn't look as ty in 1989 but that was a long time ago, the tape they use is really ty and the glue gets all gooey and falls apart leaving just some fiber strands...heatshrink and split loom plastic tubing for me thanks.
  6. Blind

    Post your Vortec engine bay!

    I have no idea, they went in with the new crate motor along with a full stainless magnaflow system, built trans, etc etc. The new engine is a lot snappier than the old rod knocking one if that helps :p
  7. Blind

    Post your Vortec engine bay!

    those are gibson shorty's, all CA smog legal here.
  8. Blind

    rear end swap question

    It doesn't take much to leave 2 black marks on the street in a pickup truck with no weight over the back, even on right/left turns. Get 1 of the rear tires stuck between a couple of rocks in sand/mud and you'll see only 1 spin - unless someone swapped the rearend before you got it.
  9. Blind

    Place to pass wiring through firewall without drilling metal?

    Where about is that located, either of you have a picture?
  10. Blind

    Place to pass wiring through firewall without drilling metal?

    I apologize, I assumed my sig was visible. The year truck I am working on is a 1996.
  11. Blind

    Place to pass wiring through firewall without drilling metal?

    Having trouble finding a DIY on this, I'm adding some wiring for indicator lights for my electric fan operation and manual switch, and likely a power lead for my inverter. Usually I can just follow somebody's big fat stereo wire install DIY and be good to go. But everything I'm seeing for...
  12. Blind

    rear end swap question

    that's about $300 too high, go find a diy junkyard like www.pickapart.com in your area and find a rearend on a 1/2 price weekend, $100 drum to drum. my tahoe has a factory 3.73 w/g80 rear, so they can't be all that hard to find.
  13. Blind

    2dr crate motor swap

    More little stuff, had the a/c system gone through and charged up last weekend, so I re-wired the mark8 fan with a 3 relay setup to have the option of low and high speeds, currently low runs with key on and high can be used by a manual switch. Then while I was at it I swapped on my under...
  14. Blind

    96 5.7 ECSB - Still Misfiring - Which cap is best?

    there's many ways. https://www.google.com/search?q=smoke+test+for+vacuum+leak&oq=smoke+test&aqs=chrome.0.69i59j69i57j5j0.1473j0&sourceid=chrome&ie=UTF-8&qscrl=1
Top