Recent content by barebones 1500
-
5.3 Engine Swap Questions
Ok, Do I have to have a tune done or will the stock programming work since i am not changing nothing.- barebones 1500
- Post #11
- Forum: Engine Performance + Maintenance
-
5.3 Engine Swap Questions
I have read on other forums that the stock pcm for the 5.3 will run all the gauges in an OBS but i can't find anything saying what wires to hook up at what location.- barebones 1500
- Post #6
- Forum: Engine Performance + Maintenance
-
5.3 Engine Swap Questions
Thanks for the proper Motor identification. I have read that the 411 swap is the way to go but i really see no need for it. More or less i was kinda thinking of freshening up my truck and this drive line fell into my lap for free. If i don't need to sink a bunch of money into this than i don't...- barebones 1500
- Post #4
- Forum: Engine Performance + Maintenance
-
-
5.3 Engine Swap Questions
Long story short, My truck (97 k1500 ECSB 5.7) Has some tranny problems that come and go and have the opportunity to get a new driveline. The donor is a 2002 GMC Sierra 4x4 5.3 ( I think it that would be a LS1 but i could be wrong) and i have the entire truck. I have been researching the last...- barebones 1500
- Thread
- Replies: 11
- Forum: Engine Performance + Maintenance
-
4L60E Problems
Long story short in march I bought a 99 GMC Sierra Classic and after only having it for 2 hours a guy runs a red light and t bones me. truck was totaled but still ran and drove fine ( frame was as far as 61 mm out in some spots and nearly every bit of frame got tweaked in one way or another). In...- barebones 1500
- Thread
- Replies: 0
- Forum: Transmissions
-
dropped93 sierra build
Been gone for the better part of a year and this is the first thing i see. Nice, Hope you get more done to it soon.- barebones 1500
- Post #810
- Forum: Lowered and Bagged Suspension
-
VSS Going Bad?
thats what mine did for a couple of months and then quit. i always figured it was a wireing issue but i never looked into it.- barebones 1500
- Post #4
- Forum: Engine Performance + Maintenance
-
VSS Going Bad?
That or one of the wires is going bad. I would replace the sensor and check the wires as well- barebones 1500
- Post #2
- Forum: Engine Performance + Maintenance
-
Catback Installed
NICE. I like that deep tone it has. When you get on it does it scream like a banshee?- barebones 1500
- Post #2
- Forum: Exhaust
-
sludge
There are all sorts of additives that clame to clean it out but the only thing i have seen that works is tranny fluid. You just gotta make sure that it all is flushed out good before running it. I have never done it but i know some people here have so maybe one of them will chime in to give up...- barebones 1500
- Post #3
- Forum: Engine Performance + Maintenance
-
Here from michigan with the story behind my truck
Welcome to the forum. What part of MI are you in?- barebones 1500
- Post #10
- Forum: Introduction
-
HELP! figure this one out! 4.3 lurching and falling
What about the MAP sensor, that will cause similar problems. Thats my best idea that makes sense- barebones 1500
- Post #4
- Forum: Engine Performance + Maintenance
-
what is 411pcm upgrade?
Here is a link to a good thread. Aloicious knows everything i swear. http://www.gmt400.com/forum/showthread.php?3389-12200411-(411)-PCM-swap- barebones 1500
- Post #5
- Forum: Audio + Electronics
-
Depression
It can be bad too cause for me what started as a resto/simple drop turned into full air-ride frame layin cruiser.- barebones 1500
- Post #9
- Forum: Street Chat / Timeslips
